AXIOMTEK DSP300-318 Series User manual

©Copyright 2020 Axiomtek Co., Ltd.
Version A2 August 2020
Printed in Taiwan
9 12K300010E
d. Raise the front part of the main board by slightly
pressing the bottom side down.
e. Remove the main board from the back cover by
lifting the board upward
(as illustrated in the figure below)
WARNING! To prevent damaging the main board and its delicate
components, DO NOT forcefully pull the main board forward or
backward without lifting the board first.
DSP300-318 Quick Installation Guide
©Copyright 2020 Axiomtek Co., Ltd.
Version A2 August 2020
Printed in Taiwan
9 12K300010E
1
Packing List
System Unit x 1 DVD/CD x 1 (for Driver & Manual)
Quick Installation Guide x 1 36W power adapter x 1
US power cord x 1 or
EU power cord x 1 Foot Pad x 4
 Do not try to apply power to the system if any damaged components.
Dimensions
DSP300-318 Series Digital Signage Player

©Copyright 2020 Axiomtek Co., Ltd.
Version A2 August 2020
Printed in Taiwan
9 12K300010E
2
I/O Outlets
The following figures show I/O outlets on the DSP300-318.
 Front View
 Rear View
1 12VDC power input 9 Line-out
2 DP 10 USB 3.0
3 HDMI 11 SIM card
4 Serial Port 12 Reset switch
5 USB 2.0 13 Power switch
6 USB 3.0 14 HDD LED
7 GbE LAN ports 15 Remote power switch
8 MIC-in
© Copyright 2020 Axiomtek Co., Ltd.
Version A2 August 2020
Printed in Taiwan
9 12K300010E
3
Installation of SO-DIMM Memory
* To save your installation effort, we recommend purchasing all
memory modules from Axiomtek, and we will have them fully
installed in the system unit prior to delivery.
* Before assembly, please adjust screw torque force to 4.0~6.0 kgf-cm.
Installation of Memory SDIMM1 Device
Please refer to User manual, if you like to know the installation with
detail.
CAUTION: The main board contains delicate components and can
be easily damaged during removal. To prevent damaging the main
board and its components, follow the instructions below to remove the
main board.
a. Identify the positioning openings on the main board,
as highlighted in the picture below. Also notice the
positioning posts underneath that come through the
openings from the back.
b. Use both hands to hold the main board by the left and
right sides.
c. To prevent the positioning posts underneath from
scratching the main board, gently lift the board
vertically upwards; until all openings are completely
separate from the posts underneath. Then slightly pull
the main board backward, until the board’s top left and
right edges have left the back cover frame (as marked
in the figure below).