Azden SMX-100 User manual

ELECTRET CONDENSER STEREO SHOTGUN MICROPHONE
© 2013Azden Corporation 012-34485-01
Printed in Japan
Azden Corporation warrants, to the first purchaser, that the Azden brand product
purchased is free from defects in material and workmanship. Azden's sole obligation
under this warranty shall be to provide, without charge, repair or replacement
(at Azden's sole discretion), within two years from the date of purchase. A dated receipt
acts to establish the date of purchase.
This warranty is the sole and exclusive express warranty with respect to the product
and all other warranties, expressed or implied, are hereby excluded. Neither Azden,
nor the dealer who sells this product, is responsible for indirect, incidental or
consequential loss and/or damages.
This warranty does not extend to any defect, malfunction or failure caused by misuse,
abuse, accident, faulty hookup, unauthorized modification or defective associated
equipment for which it is not intended. Please read your owner's manual carefully.
For a service/repair under this warranty, please contact your Azden distributor listed
at www.azden.co.jp/global.html
TWO-YEAR WARRANTY
Customers in the Asian and Oceania markets contact:
Azden Corp., 1-12-17 Kamirenjaku Mitaka-shi,T okyo, 181-8533 Japan
voice - 81-422-55-5115(Japan) • fax - 81-422-55-0131(Japan)
email - [e-mail]
Customers in the North/South America and Europian markets contact:
Azden Corp., 200 Valley Road, Suite 101, Mt. Arlington,NJ 07856
voice - 973-810-3070 • fax - 973-810-3076 • email - [e-mail]
SMX-100
Operating Manual
All manuals and user guides at all-guides.com

Thank you for purchasing the Azden SMX-100 Electret Condenser Stereo Microphone.
Before using the product, please read this operating manual thoroughly. Keep this
manual along with the warranty card for future reference.
POWER
The SMX-100 must be powered by Phantom-
Power. To power the unit, connect an XLR cable to
the microphone from a voltage source that supplies
between 11 and 52VDC. (see wiring diagram below)
MIC Output:
The SMX-100 has a balanced 5-pin XLR
connector.
SHOCK-MOUNT HOLDER
The SMX-100 is supplied with a cameramountable
mic holder. Snap the near portion of the
microphone into the holder. To secure the holder,
slide the holder into the camera shoe and tighten the
thumbwheel by turning it clockwise.
SPECIFICATIONS
Type:
Frequency Response:
Sensitivity:
Impedance:
Maximum SPL Input Level:
Signal to Noise Ratio:
Power:(Phantom-Power)
Weight:
Dimensions:
Output Type:
Supplied Accessories:
Electret condenser stereo microphone
20−18,000Hz
Uni-directional; -33dB at 1kHz (1V/Pa)
180Ωat 1kHz
120dB SPL (1kHz at 1% T.H.D.)
70dB (1kHz at 1Pa)
11 - 52V DC
110g/3.88oz
21mm diameter/220mm length
0.827diameter / 8.66length
5-pin XLR connector.
Shock-mount microphone holder
Windscreen
FREQUENCY RESPONES POLAR PATTERN
* Due to constant improvements, specifications are subject to change without notice.
shield1 5R cold
L hot 2 4R hot
3 L cold
-70
-65
-60
-55
-50
-45
-40
-35
-30
-25
-20
50 100
20 500
Hz
1k 2k 5k 10k 20k
0゜
90゜
270゜ 0.50.5
180゜
0.5
0.5
1kHz
R ch
0゜
90゜
270゜ 0.50.5
180゜
0.5
0.5
1kHz
L ch
200
All manuals and user guides at all-guides.com