BARRON TRACE-LITE RHL-ACR User manual

IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
Technical Support ■ [phone] ■ [email protected]
RHL-ACR, RHL-ALR, RHL-ACFR
Installation Instructions
20070151 REV 2 - 12/19 1 800-533-3948 www.barronltg.com

RHL-ACR, RHL-ALR, RHL-ACFR
Installation Instructions
20070151 REV 2 - 12/19 2 800-533-3948 www.barronltg.com
Refractor/Reflector Installation Instructions
1. Start this installation after the fixture is completely installed, secure and powered off.
2. Find the (3) mounting screws and (3) washers from Refractor/Reflector packaging.
3. Install the Refractor/Reflector to the lower surface of the fixture. Align the (3) mounting holes of the Refractor/Reflector
with the corresponding mounting holes on the RHL fixture (Fig. 1).
4. Secure Refractor/Reflector to the fixture with (3) Refractor/Reflector mounting screws and washers. Use thread locking
liquid (supplied by others) (Fig. 2).
5. Check security.
6. Installation complete.
Fig. 1 Fig. 2
Fixture
Reflector/Refractor
Fixture
Reflector/Refractor
Reflector/Refractor
Mounting Screws