Belnick GO-2286M-BK-GLD-GG User manual

Leather Executive Swivel Chair
Customer Service email: [email protected] | phone: [phone]
GO-2286M-BK-GLD-GG,GO-2286M-WH-GLD-GG,GO-2286M-BK-RSGLD-GG,GO-2286M-WH-
RSGLD-GG,GO-2286M-BK-BK-GG,GO-2286M-BR-BK-GG,GO-2286M-GR-GG
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components
may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death or
damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult
supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/GO-2286M-BR-BK-GG.pdf

PARTS
STEP 1 STEP 2 STEP 3
STEP 4
STEP 5 STEP 6
⑴x5 ⑵x1 ⑶x1 ⑷x1
⑸x1 ⑹x1
⑾x
⑺x1
(L&R)
⑻x
⑼
x4
⑽x4
STEP 7
⒀x1
⑺
(3)
(2)
(1)
⑽
( 3 )
⑹
⑿x4
⑷
⑸
⑽
⑽
⑽
⑹
⑺
⑾
⑾
⑻
⑿
⑿
⑸
FRONT
⑹
⑼
Op en the Velcro on both sides of seat first,
then place the Back Cushion⑺on the
Seat Cushion (6),and use 2 bolts
⑽ to
attach to the lower screw holes on Seat
Cushion (6) (see diagram).
*Note: DO NOT FULLY TIGHTEN BOLTS.
Push the Back Cushion ⑺up to a vertical
position and attached the Seat Cushion(6)
to by using 2 bolts
⑽ , then to cover the
Velcro back.
*Note: Tighten the bolts completely.