BENE FRIENDS WALL HOOKS User manual

USER MANUAL
WALL HOOKS

RECOMMENDATIONS
Please read the following instruction carefully and use the productaccordingly.
This summary may not include every detail of all variationsand considered
steps.Please contact us should yourequirefurther information or help at any time.
• Wipe clean withadry cloth for daily care.
• Please assemble this product in accordance with the
instructions.
• Wipe clean with a dry cloth for daily care.
• Should you find that you are missing/ or that youhavereceiveddefective parts
after unpacking, please contactusimmediately and do not attempt to assemble the
product.
WARNINGS
• Each element has a weight loading of up to 2 kg (11lbs).
Before using bFRIENDS Wall Hooks, make sure they are mounted safely and
correctly.
• Proper and secure wall mounting of your bFRIENDS Wall Hooks is crucial.
The correct mounting method depends on the type of wall you are attaching it to.
It is advised to use arawl plug to securely fix the hooks to the wall. If uncertain,
seek advice from your local hardware store.
• PLA becomes malleable and soft above 50 °C. 3D-Printed parts of bFRIENDS are
therefore not suitable for cleaning in the dishwasher and should be kept away
from heat.

1. Drill an 8 mm hole into your
walland insert a rawl plug. Then,
screw in the providedbolt.
2. Attach your hook by
screwing it onto the bolt.
3. Mount the 3D-printed part. Note:
It is important to properly position
the 3D-printed hook element over the
wooden part, to avoid damaging it.
Please ensure that the curvature of
the hook perfectly follows that of the
wooden part.

Bene GmbH
Schwarzwiesenstraße 3
3340 Waidhofen/Ybbs
Österreich
BENE.COM