BGS technic 8464 User manual

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 8464
Silentblocks Tool Kit | for Fiat
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool is used for mounting of rear axle silent blocks on Fiat Stilo (2001-), Fiat Bravo (2007-) and
Lancia Delta (2008-).
SAFETY INFORMATIONS
•Read carefully the instructions before working with this tool set.
•Do not use this tool set for other purpose for which it is designed.
•Lifting of vehicles only allowed on the special lifting points.
•Before starting work under a car always ensure that it is adequately supported by axle stands
or ramps. Chock wheels and ensure that the hand brake is firmly applied.
•Always use approved eye protection, especially when working under vehicles.
•Ensure a secure and well-gripped stance during fitting.
•Ensure that tools are correctly mounted.
•Regularly check the condition of the tool and replace the damaged parts.
•Do not over tighten or use undue force as this can cause damage to both tool and component.
•The tool is not suitable for air impact wrenches. The use of an air impact wrench may lead to
the spindle bearing or other components bursting and fragments of components flying around
may lead to injuries.
•Always use workshop manual for detailed instructions.
•Always lubricate the screw threads before using the tool.
•Check & replace any damaged components as required.
•Keep children and unauthorized persons out of the working area.
•Keep this tool out of children reach.
COMPONENTS
1 Spindle
2 Spindle nut with bearing
3 Thrust plate with bores
4 Pins
5 Thrust plate

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
SILENTBLOCKS
This tool set is suitable for following
bushes with e.g. original part numbers:
50700796, 50702649, 50706312,
50706505, 51795336, 51812443,
51840600
USE
1Spindle
2Spindle nut with bearing
3Thrust plate with installed pins (4)
4Thrust plate
ARear axle
BBush
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information. Dispose of this product at the end of its working life environmentally.