BGS technic 9088 User manual

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 9088
Tool Tray 1/3:
Assembly Tool Set
for Parking Sensor Holders
INTENDED USE
The assembly kit is used to replace defective parking sensor brackets or to punch holes in
unprepared plastic bumpers. Handle the tools with care and carefully clean the bracket and locator
pin after use. Lightly grease the screws and threads in the hole punches before use. Please do not
use any kind of air tools to pull the hole punches. Use the hole punches solely on plastics. Using it in
other materials such as metals will destroy the hole punch.
CONTENTS
Hole punch Ø 18.2 mm
Hole punch Ø 26.0 mm
Locator pin, red
Locator pin, silver
Holding fixture, 4 pcs.
HSS twist drill Ø 10.2 mm
USE
Many plastic bumper providers only offer a version
without parking assistance. As a result, the holes for the
parking sensors are often missing in the new plastic
bumpers. They have to be made first. First check to see
of the positions of the parking sensors are marked on the
plastic bumper. If not, find the positions with the aid of the
repair manual from the vehicle manufacturer or the
plastic bumper manufacturer. The positioning could looks
like shown in figure.

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
First drill a hole in the centre of the circle.
Use the bracket you want to install to choose the correct hole punch. Position them as shown in
figure.
Turn the screw with an appropriate tool and make sure that the counter-piece of the hole punch
does not turn on the outside.

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
INSTALLING A BRACKET WITH ADHESIVE TAPE
Some parking sensor brackets come with very strong adhesive tape. Use a locator pin to precisely
position and glue it on. Before installation, please thoroughly clean and degrease the adhesive
point. Please remember to paint the bracket / sensors before installation if applicable.

BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: [phone]
Fax.: [phone]
[e-mail]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
INSTALLING A BRACKET WITH AN ADHESIVE SUBSTANCE
Many brackets have to be glued to the inside of the plastic bumper. Before you start gluing the
bracket, please first drill and press all required holes in the plastic bumper. Please refer to the
vehicle manufacturer’s information to find out which adhesive substance you should use. Use the
holding fixture. Assemble them as shown in figure below.
Please apply a sufficient amount of adhesive substance to the intended point on the bracket. Then
position the bracket as shown in figure. Permanent fixing is achieved with the black clamp fitting
and a knurled nut. After curing, please dismantle the holding fixture and remove any glue remnants
from it.