Black Horse Off Road BB009704 User manual

TEL: I-866-)LA.NATOS
INSTALLATION IN STRUCTIOI{S
PART # BB00 97 04 t88009704A
BULL BAR FOR GMC ACADIA/SATLRI{ OUTLOOK (}7-1(}

B - -- B.1F- f OF GN,iC ACADI.:, S :.- - R'- i. l_lrli !
FARTS I-IST:
lSport Bar i2-1.75mm x 30mm i-lex Head Botts
Drive;',/Left lvlountinc Bracxet 612mm Nvlock Nuts
Passenqer l Mountinc Bi-acket 12 12mm lD x 37mm OD x 3mm Flat Washers
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING REQUIRED
Measure from the driver outer edge of the air dam 23" towards the inside of the car and mark the location
Use a hack saw to cut a 1" x 3 %" gap on the air dam (Figure 1)" NOTE: Use the mark as center of the
cutting location.
3. Remove the driver side factory hex nut located on the cross member bar. This is the hex nut that mounts the
radiator support (Figure 2).
Locate the driver side motor mount bushing. Use a 15mm socket to remove the two front (small) bolts.
Proceed to loosen up the rear (large) bolt just enough so you can slide the Mounting Bracket in between
motor mount support and frame (Figure 2).
Slide the slotted opening on the Mounting Bracket around the radiator support bolt and between radiator
bracket and frame, while you slide the Mounting Bracket between motor mount bushing (Figure 3).
Once the Mounting Bracket is in place, use the included 3lB" x 1" Self Tapping Bolt to attach the outer front
facing Mounting Location on the Bracket to the factory hole on the cross member bar. Re-install the factory
hex nut and the two bolts removed from the motor mount bushing. Tighten all hardware at this time including
the iarge bclt on the rnotot'mount bushing and fi'arire (figure 4). Tighten iarge motor mount boit to 75 ft lbs.
Repeat steps 2 - 6 for passengei'side fulounting B:"aekei.
With help position the Sport Bar on the outer side of Mounting Brackets. Attach Sport Bar to Mounting
Brackets using the included (6) 12mm x 30mm Hex Head Bolts, (6) 12mm Nylock Nuts, and (12) 12mm Flat
Washers (Figure 5).
Level and adjust Sport Bar properly; and then tighten all hardware at this time.
10" Do periodic inspections to the installation to make sure that all hardware is secure and tight.
1.
.t
4.
5.
b.
7.
8.
q
I
I
l
i
I
I
I
i
2 318' x 'i " Self Taooino Bolts
Pagel ol2

B'i ' - B.-R- FOF. CMC AC.+D]a S.i.TaP.:" OUT;-OC|i
{Eriver Sicie Mountinc Srackei lnstallatiore Showni
Remove this
factory nut Remove these
two factory bolts
Slide Mounting Bracket
between cross member bar
and radiator suPPort bracket
Slide Mounting
Bracket between
motor mount bushing
12mrn x 30mm Hex Head Bolts
12mm NYlock Nuis
12mm Flat Washers
Loosen up this
factory bolt
Factory
hex nut