Black Widow Security BW 690-C User manual

Congratulations on your purchase of the Factory Keyless
Upgrade security system. Your Factory Keyless Upgrade is man-
ufactured in the U.S.A. and designed by leading security experts
using the latest state of the art technology.
Items supplied with the Factory Keyless Upgrade
• Receiver and control module
• Valet/override switch
• Wiring harness, fuseholder & fuse
• LED status indicator
• Siren (optional)
• Shock sensor (optional)
OWNER’S MANUAL
FACTORY KEYLESS UPGRADE
1

The Factory Keyless Upgrade is designed to interface with your
existing factory keyless system and will not interfere with its
operation.The system comes with an L.E.D. and override switch.
This system may also come with dual zone shock sensor and
multi tone siren.
Arming Operation: Simply press the lock button on your
factory remote and you will hear one chirp from your
horn/siren, your parking lights will flash one time (optional).
Your doors will lock, the L.E.D.will turn on solid for 10 seconds
then it will start flashing slowly. Once the LED starts slowly
flashing your system will be fully armed.
Disarming Operation: Press the unlock button on your
factory remote, the siren/horn will chirp twice, your parking
lights will flash twice (optional).The L.E.D. will stop flashing, the
doors will unlock and your system is disarmed. (See Security
Modes)
Passive Arming: If your installing dealer installed the system
to passive arm, the system will arm 30 seconds after the last
door has been closed. It will not lock the doors. To disarm the
system simply follow the disarming operation above. When the
system is in the pre-arm mode the led will flash rapidly to let
you know that it ready to arm the system in 30 seconds.
Valet Mode: Valet mode will keep your alarm system from
passive arming (if programmed to be passive arming), if you need
to have your vehicle serviced, or run it through a car wash etc.
To put your vehicle in Valet Mode, turn the ignition key on and
2

press and hold your valet/override switch in for approximately 5
seconds, the L.E.D. will turn on solid.You vehicle’s system is in
Valet Mode. Deactivate Valet Mode:It will stay in Valet until you
repeat the procedure and the L.E.D. will turn off.
Security Modes: Your system can be programmed 2 differ-
ent ways depending on the vehicle and the additional security
components that are added to it.
Security level 1:The alarm system will simply turn off when you
press unlock button on the remote or by unlocking your car doors.
Security level 2:The alarm system can only be turned off when
the unlock button of the remote control is pressed.
LED Status Modes:
Valet= Solid
Pre Arm Active=Solid for 10 seconds
Armed=Slow flash
Disarmed=Off
Pre Arm Passive= Rapid flash
System triggered while away=Slow double flash
Operating Override/Valet Switch
Valet=Ignition switch on, press override/valet switch for
5 seconds.
Disengage Valet=repeat above process.
Manual Override System=Ignition On press switch
3

© David Levy Company, Inc., BW-690C Rev. 2, October, 2000 •Cerritos, Ca 90703