Black Widow Security BW 700 User manual

Congratulations on your purchase of the Factory Keyless
Upgrade security system. Your Factory Keyless Upgrade is
manufactured in the U.S.A. and designed by leading security
experts using the latest state of the art technology.
Items Supplied with the Factory Keyless Entry
• Receiver and control module
• Valet/override switch
• Wiring harness, fuseholder & fuse
• LED status indicator
• Siren*
• Shock sensor*
* NOT INCLUDED WITH “E” MODELS
OWNER S MANUAL
SERIES 700/700E
FACTORY KEYLESS UPGRADE
1

The Factory Keyless Upgrade is designed to interface with an
existing factory keyless entry system, converting it to a full
security system.
Arming Operation:
To Arm the system, press the lock button on the factory remote.
The horn/siren will chirp once.
The parking lights will flash once (optional).
The doors will lock.
The LED will turn on solid for 2 seconds, then begin flashing
slowly. Once the LED starts flashing the system will be fully
armed.
Disarming Operation:
To Disarm the system,press the unlock button on the factory remote.
The horn/siren will chirp twice.
The parking lights will flash twice (optional).
The doors will unlock.
The LED will stop flashing.
Passive Arming:
The passive arming feature may be selected selected during
installation to keep the vehicle secure in the event the user
forgets to arms the system upon exiting the vehicle. After the
ignition is turned off and the last door is closed, the led will flash
rapidly signifying that the system will arm in 30 seconds. After 30
seconds the sytem will arm as described under Arming Operation,
but the doors will not lock.
2

Valet Mode:
In the event the vehicle requires servicing, washing, etc., the Valet
Mode can be activated to disable the alarm, while still allowing the
keyless entry feature to operate. The Valet Mode will also disable
the system’s passive arming feature (if programmed for passive
arming). To enter Valet Mode:
Turn the ignition key on.
Press and hold the valet/override switch for approximately 5
seconds.
The LED will turn on solid indicating the system is inValet Mode.
To exitValet Mode repeat the procedure above. The LED will turn
off indicating the system has exited Valet Mode.
Emergency Override
In the event the remote transmitter is lost or stolen, the
Emergency Override feature may be used to deactivate the
system. To override the system:
Turn the ignition key on.
Press and hold the valet/override switch for approximately 5
seconds.
The LED will turn off indicating the system is disarmed.
LED Status Modes:
Valet = Solid
Pre-Arm State = Solid for 2 seconds
Armed = Slow flash
Disarmed = Off
Passive Arming Sequence = Rapid flash
System triggered while away = Slow double flash
3

© David Levy Company, Inc., BW-700E Rev. 1, 01/01 • Cerritos, CaA 90703