BluDot Peek Small Media Stand Quick start guide

Peek Collection
DESIGNED IN 2016
ASSEMBLY NOTES | REV 00
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.
THE HOLE SHEBANG.
What is missing makes the mojo in this new wood case good
collection. A round cut out in drawer and door front acts as the
pull, creating function and visual appeal.

1 | 844.425.8368 PEEK COLLECTION
Case
1QTY
8041
Anti-tip Bracket
Pt. 8041
2QTY
8042
Anti-tip Strap
Pt. 8042
1QTY
Pt. 1218
2QTY
Pt. 1217
QTY 2
Pt. 1616
16QTY
Pt. 9021
1QTY
Leg
4QTY
Parts & Hardware

[e-mail] | 2ASSEMBLY NOTES
PT. 1616 x 16 PT. 9021 x 1
Step 01
ATTACH THE LEGS.
After the legs have been attached, have a
second person help lift and bring the case
upright in order to prevent leg damage.

3 | 844.425.8368 PEEK COLLECTION
8041
Anti-tip Bracket
PT. 8041 x 1PT. 1218 x 2
Wall
1” lower than
case top
Side Panel
Step 02
ATTACH ANTI-TIP BRACKET TO THE WALL.
Install anti-tip bracket to wall stud 1-inch
below case top panel height.

[e-mail] | 4ASSEMBLY NOTES
8041
Anti-tip Bracket
PT. 8041 x 1PT. 1218 x 2
Back
Panel
Top
Step 03
INSTALL ANTI-TIP BRACKET TO CASE.
Bracket must be installed to top panel of case.
In order to prevent damage, it is recommended
that 3/32” pilot holes be drilled prior to
installation.

5 | 844.425.8368 PEEK COLLECTION
8042
Anti-tip Strap
PT. 8042 x 1
Step 04
SECURE THE CASE.
Install and tighten the strap prior to using the
product.

[e-mail] | 6ASSEMBLY NOTES
12
3
If door needs adjustment from
TOP TO BOTTOM, Use Screw #1.
If door needs adjustment from
SIDE TO SIDE, Use Screw #2.
If door needs adjustments from
FRONT TO BACK, Use Screw #3.
DOOR ADJUSTMENT.
Hinges work in pairs. If you adjust one hinge, chances are you will have to adjust all the hinges.
Additional Information

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
CLEAN
Clean with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality cleaner formulate
for wood furniture. Wipe completely dry with a soft cloth in the direction of the wood grain.
Additional Information
TO REMOVE DRAWERS
Extend the drawer completely. Squeeze both locks on the
underside of the drawer while pulling the drawer out.
TO REINSTALL THE DRAWER
Pull both slides forward. Engage rear slide catches. Lower drawer front into place and push closed.