BluDot Rule Chiffonier Quick start guide

Rule Collection
DESIGNED IN 2016
ASSEMBLY NOTES | REV 00
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.
YOU FOLLOW?
Hot for geometry. Giddy for grids.The Rule collection serves up
well considered planes and angles that are ready to slay clutter
and get your room in formation.

1 | 844.425.8368 RULE COLLECTION
Case
1QTY
8041
Anti-tip Bracket
Pt. 8041
2QTY
8042
Anti-tip Strap
Pt. 8042
1QTY
Pt. 1218
2QTY
Pt. 1217
QTY 2
Parts & Hardware

[e-mail] | 2ASSEMBLY NOTES
8041
Anti-tip Bracket
PT. 8041 x 1PT. 1218 x 2
Wall
1” lower than
case top
Side Panel
Step 01
ATTACH ANTI-TIP BRACKET TO THE WALL.
Install anti-tip bracket to wall stud 1-inch
below case top panel height.

3 | 844.425.8368 RULE COLLECTION
8041
Anti-tip Bracket
PT. 8041 x 1PT. 1218 x 2
Back
Panel
Top
Step 02
INSTALL ANTI-TIP BRACKET TO CASE.
Bracket must be installed to top panel of case.
In order to prevent damage, it is recommended
that 3/32” pilot holes be drilled prior to
installation.

[e-mail] | 4ASSEMBLY NOTES
8042
Anti-tip Strap
PT. 8042 x 1
Step 03
SECURE THE CASE.
Install and tighten the strap prior to using the
product.

5 | 844.425.8368 RULE COLLECTION
Additional Information
TO REMOVE THE SLIDING SHELF
Pull lever up on the right side and push down on the left side
of the shelf slide. With levers engaged pull shelf out.
TO REINSTALL THE SLIDING SHELF
To install the sliding shelf extend drawer slides out from case, align with shelf slides as shown,
and slide shelf in. Be sure to push until shelf is completely engaged.

[e-mail] | 6ASSEMBLY NOTES
Additional Information
TO REMOVE DRAWERS
Extend the drawer completely. Squeeze both locks on the
underside of the drawer while pulling the drawer out.
TO REINSTALL THE DRAWER
Pull both slides forward. Engage rear slide catches. Lower drawer front into place and push closed.

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
CLEAN
Clean with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality cleaner formulate
for wood furniture. Wipe completely dry with a soft cloth in the direction of the wood grain.
Additional Information
TO ADJUST LID STAYS
Open door and locate lid stay mechanisms. To reduce tension , turn adjustment screws counterclockwise.
To increase tension, turn adjustment screws clockwise
TO ADJUST DRAWER FACE
To adjust drawer face alignment pull the drawer out until the undermount release is visible. Then
turn the adjustment wheels until the drawer face is properly aligned.