BluDot Hang 1 Quick start guide

Hang 1 Mirror Collection
DESIGNED IN 2016
ASSEMBLY NOTES | REV 01
@BLUDOT
We design all our pieces in our Minneapolis studio. Follow
along on Instagram for some sneak peeks into the process.
NEED A HAND?
Contact us at [email protected] or
844.425.8368 for assistance.

1 | 844.425.8368 HANG 1 MIRROR COLLECTION
Pt. 1202
Bumper
Mirror*
*Mirror shape may vary depending on the size/shape that was purchased.
Pt. 8036
Wall Peg
1
3
1
1
1
QTY
QTY
QTY
QTY
QTY
Parts & Hardware

[e-mail] |2ASSEMBLY NOTES
Pt. 1202 x 1Pt. 8036 x 1*
Step 02
ATTACH BUMPERS
Carefully place the mirror face down on a soft
surface. Peel the backing off of the bumpers
as shown to reveal the adhesive sticker. Attach
bumpers to the back side of the mirror by
sticking them to the mirror as shown.
NOTE:Do not peel the backing sticker off of
the mirror itself.
Step 01
ATTACH WALL PEG
An anchor and fastener are included for
installation. Please consult your local
hardware professional to determine the
hardware best suited for your wall type.
If the mounting location is not positioned on a
stud, drill a 5/16” hole in the marked location
and insert anchor as shown. If the mounting
location is located on a stud, this step of
installing an anchor may be skipped. Instead,
drill a 1/8” pilot hole in the marked location.
Attach the wall peg to the wall using the
included fastener as shown.

BLU DOT DESIGN & MANUFACTURING, INC. DESIGNED IN MINNEAPOLIS, MN
Additional Information
CLEAN
Clean mirror with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality glass
cleaner. Wipe completely dry with a soft cloth.
Clean wood with a slightly damp, soft cloth. To remove dirt and fingerprints, use a quality cleaner
formulated for wood furniture. Wipe completely dry with a soft cloth in the direction of the wood grain.
Step 03
MOUNT MIRROR
Place the mirror onto the wall peg as shown by
aligning the mirror slot with the wall peg. Place
the mirror at the back of the peg so that it sits
securely within the groove.