Bob's Space Racers Gear It Up User manual

Bob’s Space Racers Inc. © 2015 MAY 2015 pg. 1
Bonus Wheel Plex
Cover (200 points)
Part # M0803017
Summary:
This update changes the payout ratio to a higher level while
also increasing the game difficulty. You do not need to be an
experienced technician to perform this update and simple
handle tools are all that is needed.
Kit includes the following:
1x –Instructions guide
1x –1:1 close ratio gear (Part # M0803009-4)
1x –Bonus Wheel Plex (To 200 Ticket Option) Part # M0803017
1x –Updated programmed IC
1x –Options sheet
If you have any trouble performing this update, please contact
Bob’s Space Racers Technical Support at 386-677-0761 ext 41
or email us at [e-mail]
BEFORE STARTING:
TURN OFF THE GAME AND DISCONNECT THE POWER FROM
THE GAME.
It is always a good idea to have a second person to help you.
Gear It Up™
Max. Bonus Game Play Update
Part # M0803009-6
BOB’S SPACE RACERS, INC.
1:1 Close Ratio Gear
Part # M0803009-4
Programmed IC
Update

Bob’s Space Racers Inc. © 2015 MAY 2015 pg. 2
GEAR INSTALLATION INSTRUCTIONS:
1. Remove the front glass from the game
a. Using a #2 star (phillips) type screwdriver,
remove the 3 screws that secure the glass
retaining bracket.
b. Open the front counter
c. Gently lift the glass from the slot and set
aside.
DO NOT SET GLASS ON HARD SURFACES!
2. Remove the bottom gear from the motor bracket
and set aside.
3. Remove the middle gear and move it the bottom
position
4. Remove the top gear and move is to the middle
position
5. Install the supplied 1:1 close ratio gear (orange) in
the top position.
Replace the glass in the reverse order you did
before. Be careful when replacing the glass. It
is always recommended you have a second
person to hold the glass in place as you secure
the retaining bracket into place.
BONUS WHEEL INSTALLATION
1. Using the supplied Hex head wrench (in the parts kit),
unscrew the 6 Hex type screws from the bonus wheel plex
cover.
2. Replace the bonus wheel plex cover with the updated bonus
wheel plex cover.
3. Replace the hex head screws to secure the bonus wheel plex
cover to the bonus wheel assembly.
Set aside the Gear you pulled out and the bonus wheel plex
cover in a secure location so that it may not get damaged.

Bob’s Space Racers Inc. © 2015 MAY 2015 pg. 3
3. Using a small flat head screwdriver, gently
insert it into the top of the IC and gently pry it
up. You should not have to exert too much
force to do this.
Programming Options:
Use the supplied the Options Sheet to set your game options. For instructions on how to do this, see the GEAR IT UP operators
manual section PROGRAMMING OPTIONS. The new game play will start with High Bonus Values and will increase the bonus
faster. Please start with the recommended settings and adjust as needed.
4. After you have the old programmed IC out, gently insert the
new programmed IC into the slot. Make sure you line up the
pins with the socket. Also notice there is a knotch on the
programmed IC as well as the IC socket. These knotches need to
line up.
Install Programmed IC:
1. Locate the main logic board. This is located in the back
of the game on the lower left corner. It is the largest
board in the game.
2. Next locate the programmed IC on the main logic board.
This will be the large IC with the decal on it.
Knotches
KNOTCHES
Main logic board