Bosch DCN-DIS Reference guide

DCN-DIS Discussion Unit (Dual Delegate)
Channel
selector
Volume
control
Microphone
button
Microphone
button
Legend
Speaking
Miscellaneous
Listening
Loudspeaker
On:
Microphone active
Last minute
Request-to-speak
First in list
Flashing:
On:
Voice mode
Flashing:
Channel
selector
Volume
control
On:
Microphone active
Last minute
Request-to-speak
First in list
Flashing:
On:
Voice mode
Flashing:

DCN Next Generation | Quick Reference Card | DCN-DIS Discussion Unit (Dual Delegate)
Bosch Security Systems | 2005-09 | 9922 141 70671 © Bosch Security Systems B.V. | Data subject to change without notice
en
Microphone
To enable the microphone:
Push your microphone button to enable the microphone
of the discussion unit.
• If the red light around your microphone button
comes on, you can speak.
• If the green light around your microphone button
comes on, your request-to-speak is accepted. You
cannot speak until the red light around your
microphone button comes on.
To cancel a request-to-speak:
When the green light around your microphone button is
on, push your microphone button to cancel your
request-to-speak. The operator can disable the
possibility to cancel the request-to-speak.
To disable the microphone:
When the red light around your microphone button is
on, push your microphone button to disable the
microphone. The red light around your microphone
button goes off. The operator can disable the possibility
to disable the microphone.
VIP mode
When the yellow light around your microphone button
comes on, the discussion unit is in the VIP mode. In the
VIP mode:
• You can always enable the microphone.
• You cannot make a request-to-speak.
Voice mode
When the discussion unit is in the Voice mode, the
microphone is always enabled. Push and hold your
microphone button to temporarily disable the
microphone. In the Voice mode, you cannot make a
request-to-speak.
Channel selector
With your channel selector, you can select the channel
that is sent to your headphones. Your channel selector is
automatically enabled when you connect your
headphones to the discussion unit.
Note
Some types of discussion units do not have a
channel selector. With these types of discussion
units, you cannot change the audio signal that is
sent to your headphones.