Boston Scientific Precision SC-5312 User manual

Keep charging until you hear the
DOUBLE BEEP, indicating that
the Stimulator is fully charged.
You can also check the stimulator
battery indicator on the Remote
Control to ensure that you have
completely recharged your
Stimulator’s battery.
Charging Tips
5Charging Complete 6
Charging System
Quick Start Guide
Not intended as a substitute for the provided
Precision™ Charging System Handbook (90657810 -01).
The contents of the handbook must be fully understood
before using your charging system.
All cited trademarks are the property of their respective
owners. CAUTI ON : The law restricts these devices to
sale by or on the order of a physician. Indications,
contraindications, warnings and instructions for use
can be found in the product labelling supplied with
each device. Information for the use only in countries
with applicable health authority product registrations.
Precision is a registered trademark of Boston Scientific
Corporation or its affiliates.
© 2014 Boston S cienti fic
Corporation or its affiliates.
All rights reserved.
905 558 2- 003 R ev B
3-300264_MAR2014
Printed in the U.S.A.
Authorized to affix
the CE mark in 2013 SC-5312
0123
Neuromodulation
25155 Rye Ca nyon Loop
Valencia , CA 9135 5
866.360.4747 Toll-free
87 7. 4 6 4 .2 9 4 0 Fa x
ControlYourPain.com
Occasionally check the Charger to
ensure that it is centered over the
Stimulator. Keeping the Charger
centered over the Stimulator will
ensure the shortest charging time.
The Indicator Light may turn
amber. This is NORMAL and
you may continue charging.
If the Charger requires re-charging,
it will beep slowly regardless of
Stimulator alignment.
WARNING: While charging your IPG, the Charger
will become warm. This is considered normal.
Handle the Charger with care. DO NOT USE THE
CHARGER WHEN SLEEPING. This may result in a
burn. Failure to use the Charging Belt may also
result in a burn. If you experience discomfort or
pain, cease charging and contact Boston Scientific
Neuromodulation.
Remove the Charging Belt.
Return your Charger to the
Base Station.
Locating the Stimulator
4
The Charger will beep continually
as it searches for the Stimulator.
To locate the Stimulator, place
the Charger over the implant
area and move it around until
the beeping stops.

Power Supply
1
Power
Supply
Base
Station
Charging the Charger
2
Place the Charger in the Base
Station. When your Charger is fully
charged, the light will turn green.
OVER
Using the Belt
3
Plug the Power Supply into
an outlet and connect to the
Base Station.
Green light = a full charge
Amber light = a partial charge
No light indicates that a
connection is loose.
Place the Charger in the pouch of
the Charger Belt and push the
Power Button. Close flap.
Be sure that the Charger is
directly over the Stimulator.
Wrap the Charger Belt around
your waist and insert the strap
back through the loop.
Be sure that the Charger is
facing outward.
Amber light = a partial charge
Green light = a full charge
To open, undo Velcro® strap and
pull through belt loop.
Pull the strap in the opposite
direction and secure the Velcro.
If necessary, you can adjust the
other side.