BrandMotion FLTW-7690 User manual

! INSTALLATION!INSTRUCTIONS!
FLTW-7690 instructions 9-23-16.doc Page 1 of 2 GS
4.3” display Mirror w/ 2 dual video inputs
(Kit # FLTW-7690)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Rear View mirror
Power/Video harness
D-tab (only use it you don’t have a factory
mounted D-tab)
Wire guide for mirror to headliner
These instructions
Wire strippers
Wire cutters
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Screwdriver
Socket set
Wrench
Safety Precautions:
•Work in well ventilated area that is clear of obstructions.
•Secure vehicle with tire chucks in both front and rear of tires.
•Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•Wear safety goggles and snug fitting clothes.
•Use tools only for their intended purpose and which are in good repair.
•Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com

! INSTALLATION!INSTRUCTIONS!
FLTW-7690 instructions 9-23-16.doc Page 2 of 2 GS
1. Remove old mirror from mount on
windshield as per manufacturer’s directions.
2. Install new mirror on to D-tab and tighten
with an Allen wrench.
3. Connect the power harness to the plug on
the mirror. Route the harness down the A-
pillar to the under dash to make the power
connections.
4. Connect the rear view camera to the Video
2 input on mirror power harness.
5. The video inputs on the mirror are video
sensing, so you must use the reverse 12-
volt wire in the vehicle to power the
camera.
6. Connect the RED wire from the mirror
harness to 12 volt accessory power.
7. Connect the BLACK wire to a solid ground.
8. Place the vehicle in reverse to see in the
camera image shows on the screen in the
mirror. When the image is shown on the
screen you can adjust the brightness of the
screen by pressing the power button on the
mirror. The mirror has 5 different settings
for brightness.
9. The Video 1 input can be used for a front
camera or a Cargo camera.