BrandMotion FLEETWORKS FLTW-7610 User manual

INSTALLATION(INSTRUCTIONS
Ram Promaster Camera with Optional Park Lines
(Kit # FLTW-7610)
Please read thoroughly before starting installation and check that kit contents are
complete. This kit uses existing light from vehicle PN#68169776AB
Items Included in the Kit:
Tools & Supplies Needed:
Camera
Gasket
Chassis Harness
2 Bolts
2 Washers
2 Nuts
4 Screws
Camera adjustment tool
These Instructions
Phillips Screw Driver
Wire Ties
Electrical Tape or Heat Shrink Tubing
Plastic Trim Removal Tool
Soldering Iron & Solder (Recommended)
Vehicle service manual (If needed)
Safety Precautions:
•Work in well ventilated area that is clear of obstructions.
•Secure vehicle with tire chucks in both front and rear of tires.
•Turn vehicle accessories OFF and ensure ignition key is in OFF position.
•Wear safety goggles and snug fitting clothes.
•Use tools only for their intended purpose and which are in good repair.
•Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation
instructions.
Step 1: Remove high center red light from
vehicle. Unplug connector of lamp.
Step 2: Insert connector end of the Camera
Harness through the hole.
Step 3: Mount camera base to vehicle using
the provide nuts and bolts.
Step 4: Route rear lamp connector though
camera base and surround.
Step 5: Use screws to mount camera
surround to camera base.
Step 6: Connect and mount high center red
light to camera surround using provided
screws

INSTALLATION(INSTRUCTIONS
Step 7: Route Camera and/ or Chassis
Harness along existing wiring and secure
using Wire Ties or Electrical Tape.
Step 8: Connect Camera Harness to supplied
Chassis Harness.
Step 9: Route Chassis Harness forward. It
may be necessary to remove side panels, etc. Use
a Plastic Trim Removal Tool to avoid damage to
trim pieces.
Step 10: Connect Power Harness male RCA
connector to RCA located on your Display.
Step 11: Using a vehicle specific service
guide/wiring diagram and a multi-meter
verify 12v Ignition or Reverse power source.
Red wire of power harness connects to 12v+
Ignition or Reverse power and Black wire of
power harness to Black chassis ground nut or
wire. RECOMMENDED: Solder wires and cover with
Heat Shrink Tubing or use T-taps as an optional
connection method.
Step 12:Coil any excess Chassis Harness and
secure it to existing vehicle wiring with Wire
Ties or Electrical Tape.
Step 13: Test system. Clear all removed items
from around the vehicle before starting the vehicle.
Next, shift into Reverse and check display.
Step 14: (If necessary) Adjust camera aim
using the supplied fork tool.Reposition camera
to the desired viewing angle.
Step 15: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
((((((((((((CAMERA(OPTIONS
The camera offers park lines or non park
lines
Park lines options: Default setting displays
park lines are off. To turn on park line
display, remove connector at end of camera
harness.
Connector to green wires on the Camera Harness.