Breezesta CI-1801 User manual

CI-1801
Chill Side Beverage Table
CI-1804
Chill Side Table
REV 01 - 01/21
CHILL SIDE BEVERAGE TABLE/
CHILL SIDE TABLE
CI-1801 / CI-1804
1
CI-1801 & CI-1804 Assembly

A1
A2
B
C
D
E
a b
c
SA-00442 HARDWARE KIT
PART
DESCRIPTION
PART NO.
QTY.
a
#8 x 2" TORX SCREW H-0000-S82
4
b #8 x 1-1/2" TORX SCREW H-0000-S815 4
c T20 &T25 TORX BIT H-0000-CTD 1
PARTS
PART
DESCRIPTION
PART NO. CI-1801 CI-1804
A1 TABLE TOP ASSEMBLY SA-00431 1 -
A2 TABLE TOP ASSEMBLY SA-00445 - 1
B TOP INSERT ASSEMBLY SA-00432 1 -
C MIDDLE SUPPORT ASSEMBLY SA-00433 1 1
D LEG PRT-00775 4 4
E WINE BUCKET INSERT H-0000-WB 1 -
2 CI-1801 & CI-1804 Assembly

1.
Start with a leg (D) and the Middle
Support (C). Holding the leg in a
corresponding slot in the Middle support,
fasten the leg using (1) of hardware a. The
ledge of the leg should be against the
bottom of the Middle Support and the leg
should be pushed against the inside of of the
slot. Repeat for all four legs.
*One leg not
shown for clarity
D
x4
C
a
x4
TOP VIEW
b
Leg shoulder
Bottom surface
of table top
2.
Place the Table Top Assembly (A1 or A2)
upside down on a non-marring surface. Turn
the leg assembly from the previous step and
push the tops of the four legs into the four
slots in the bottom of the table top. Make
sure the shoulder of the leg is firmly against
the table bottom. Fasten using (4) of
hardware b.
3 CI-1801 & CI-1804 Assembly

E
B
3.
Turn the assembled table
onto its feet. Slide the Wine
Bucket Insert (E) into the hole
in the center of the table.
Place the Top Insert (B) into
the table.
For Side Beverage
Table Only
4 CI-1801 & CI-1804 Assembly