Breezesta fiberon Furniture Coastal FIB-CO-0400 User manual

Coastal Upright Adirondack
FIB-CO-0400

2FIB-CO-0400 Assembly 5/21
Coastal Upright Adirondack Hardware Parts
Part Description Part Number Quantity
a#8 x 1- in. Torx Screw H-0000-S815 2
b#8 x 2 in. Torx Screw H-0000-S82 6
cDouble Screw H-0000-DS 4
d5/16 in. x 1- in. Chair Bolt H-0000-CB51615 12
eT20 and T25 Torx Bit H-0000-CTD 1
Suggested Tools
Drill
Plastic Mallet
Coastal Upright Adirondack Furniture Parts
Part Description Part Number Quantity
AFront Le Leg Assembly PRT-00138 1
BFront Right Leg Assembly PRT-00139 1
CRear Leg Assembly PRT-00140 2
DUnder Arm Support PRT-00124 2
ESeat Assembly SA-00059 1
FLe Arm Assembly SA-00057 1
GRight Arm Assembly SA-00058 1
HAdirondack Spreader SS-22.187 1
IBack Assembly SA-00048 1
a b c d e
Please read entire instructions before beginning.
D
ABC
E
F
G H
I

3FIB-CO-0400 Assembly 5/21
1. Attach Rear Leg Cto Le Arm Fby inserting
Hardware cinto the pre-drilled holes and
rotating Rear Leg Cclockwise, stopping
when the assembly is tight.
A
C
c x 2
F
D
b x 2
E
E
I
E
I
b x 2
2. Repeat step 1 with Front Le Leg A.
3. Place Under Arm Support Dinto
the pre-cut slot and attach it using
Hardware b.
4. Repeat steps 1-2 for Front Right Leg B,
Rear Leg C, Right Arm G and Under Arm
Support D.
Loosen (do not fully remove)
two slat screws on one side.
5. Loosen two of the seat slat screws on
one side of Seat Assembly E. Spread the
side rails of Seat Assembly E to insert the
bottom tenons of part Iinto their slots as
shown. Re-tighten the two screws in Seat
Assembly E.
6. Use one of Hardware bon each side to
fasten Back Assembly Ito
Seat Assembly E.

4FIB-CO-0400 Assembly 5/21
d x 6
7. Lay the seat / back assembly from step 5 and 6 on its side. Fix the assembly from step 1 to the seat / back assembly.
Start by hand-tightening Hardware din the back leg. Next, hand-tighten Hardware din the front leg. Then, hand-tighten
Hardware dthrough the middle back support up into the arm. Finally, mechanically tighten all six bolts.
a x 2
8. Lay the assembly from step 7 on its opposite side and repeat the process to
attach the opposite leg / arm assembly to the chair.
H
9. Insert one tenon of Right Arm Hinto one of the front legs.
Applying some pressure, flex the front leg to insert the
opposite end of Right Arm Hinto its slot. Fasten using two
of Hardware a.
(Back and seat base
not shown for clarity.)
©2021 Fiberon. All rights reserved. FIBERON and the Fiberon logo are trademarks of Fiber Composites, LLC. Registered trademarks are registered in the U.S. and may be registered internationally.