Breezesta CO-0300 User manual

REV07-02/21
COASTAL SWIVEL BAR CHAIR
CO-0300
1 CO-0300 Assembly

A B
C
D
E
a
b c d e
Suggested Tools:
Drill, Plastic Mallet, 1/2" Socket Wrench
F
G H
I
i j k
J
K
L
g
f h
PARTS
PART DESCRIPTION PART NO. QTY
A LEFT LEG ASSEMBLY SA-00051 2
B RIGHT LEG ASSEMBLY SA-00052 2
C SWIVEL SUPPORT ASSEMBLY SA-00085 1
D SEAT ASSEMBLY SA-00089 1
E ARM CONNECTOR ASSEMBLY SA-00086 2
F UNDER ARM SUPPORT PRT-00146 2
G LEFT ARM ASSEMBLY SA-00087 1
H RIGHT ARM ASSEMBLY SA-00088 1
I COASTAL/BB SEAT SLAT SS-17.437 2
J BASE RAIL PRT-00174 2
K FOOT REST PRT-00168 2
L BACK ASSEMBLY SA-00069 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a 1/4"-10 X 3" LAG SCREW H-0000-S103 4
b 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 2
c 5/16" X 2-1/8" CHAIR BOLT H-0000-CB516218 20
d 1" HEX BOLT 5/16" DIA H-0000-HB1 4
e #8 X 1-1/12" TORX SCREW H-0000-S815 4
f #8 X 2" TORX SCREW H-0000-S82 2
g #8 X 2-1/2" TORX SCREW H-0000-S825 4
h #8 X 3" TORX SCREW H-0000-S83 8
i DOUBLE SCREW H-0000-DS 2
j T20 & T25 TORX BIT H-0000-CTD 1
k COASTAL SWIVEL ASSEMBLY - GEN3 H-0000-SAC3 1
CO-0300 Assembly 2

T25
A
x2
B
x2
C
c
x16
T20
h
x8
K
x2
T25
k
a
x4
Rotate top plate slightly
to allow access to the
holes in the bottom
plate of the swivel.
T20
J
x2
I
x2
e
x4
2.
Connect Parts A & B to Part C &
previous assembly using Hardware c
Please read entire instructions
before beginning
3.
Attach Part K to the
previous assembly using
Hardware h
4.
Attach Hardware k to the
previous assembly using Hardware a
1.
Connect Parts I & J together
using Hardware e
3 CO-0300 Assembly

T20
F
g
x2
G
E
i
d
x4
k
c
f
x2
b
x2
7.
R
otate Part E
clockwise until tight in
the orientation shown
6.
Attach Part E to
Part G using Hardware i
8.
Place Part F into
the pre cut slot and
attach with Hardware g
9.
Repeat steps 6-8
for Parts H, E, & F
5.
Attach Part D to
Hardware k using
Hardware d
11.
Attach Back Assembly L to the
seat base using hardware f. Attach the
Back Assembly center support to each
arm using hardware b
10.
Attach the two arm assemblies
from steps 6-9 to the seat base using
hardware c
4 CO-0300 Assembly