Breezesta CI-1802 User manual

CHILL COFFEE TABLE
CI-1802
1 CI-1802 Assembly

A
B
C
E
D
ba c
d
PARTS
PARTS
DESCRIPTION
PART NO.
QTY.
A TABLE TOP ASSEMBLY SA-00440 1
B LH LEG PRT-00104 2
C RH LEG PRT-00107
2
D SPREADER PRT-00106
2
E LONG SUPPORT PRT-00105 2
SA-00443 HARDWARE KIT
PARTS
DESCRIPTION
PART NO.
QTY.
a #8 x 1-3/4" TORX SCREW H-0000-S8175 8
b #8 x 2" TORX SCREW H-0000-S82 4
c DOUBLE SCREW H-0000-DS 4
d T20 & T25 TORX BIT H-0000-CTD 1
2 CI-1802 Assembly

C
x2
1.
Lay the table top (A) upside down on a non-
marring surface. Start an end of a double screw (c) in
the hole in the top of each leg (B & C). Thread the
opposite end of the double screw/leg into the open
holes at the four corners of the table top. Rotate the
double screw/leg assembly clockwise until the top of
the leg is tight to the bottom of the table and the slots
on the legs face the inside of the table.
B
x2
2.
Using (4) of hardware (a),
fasten a long support (E) to the
inside of the the legs on one
side. There are 2 shallow holes in
each leg to act as a guide for
the screws so the support is
positioned correctly. Once the
first side is done, repeat for the
second side.
c
x4
E
x2
TIP:
When attaching
the long support, be
sure it is clear of the
slot in the leg.
a
x8
Long Support
clear of slot
3 CI-1802 Assembly

D
x2
b
x4
3.
Insert a tenoned end of the spreader (D) into the slot in a leg as shown
above. The tenon is offset and should be toward the center of the chair. With
some pressure, pull outward on the opposite leg and pop the other end of
the spreader into the leg slot. Repeat this on the opposite end of the table.
Fasten the spreaders using (4) of hardware (b), (1) screw in each end of each
spreader.
4.
Flip the table onto its legs.
4 CI-1802 Assembly