Breezesta COASTAL UPRIGHT ADIRONDACK CO-040 User manual

REV03-7/19
COASTAL UPRIGHT ADIRONDACK
CO-0400
1 CO-0400 Assembly

A
B
C
D
F
E
a b c d e
Suggested Tools:
Drill, Plastic Mallet
G
H
I
PARTS
PART DESCRIPTION PART NO. QTY
A FRONT LEFT LEG PRT-00138 1
B FRONT RIGHT LEG PRT-00139 1
C REAR LEG PRT-00140 2
D UNDER ARM SUPPORT PRT-00124 2
E SEAT ASSEMBLY SA-00059 1
F LEFT ARM ASSEMBLY SA-00057 1
G RIGHT ARM ASSEMBLY SA-00058 1
H ADIRONDACK SPREADER SS-22.187 1
I BACK ASSEMBLY SA-00048 1
HARDWARE
PART DESCRIPTION PART NO. QTY
a #8 X 1-1/2" TORX SCREW H-0000-S815 2
b #8 X 2" TORX SCREW H-0000-S82 6
c 5/16" X 1-1/2" CHAIR BOLT H-0000-CB51615 12
d DOUBLE SCREW H-0000-DS 4
e T20 & T25 TORX BIT H-0000-CTD 1
CO-0400 Assembly 2

A
C
d
x2
F
T20
b
x2
D
E
I
T20
b
x2
I
E
E
LOOSEN (do not fully remove) 2 SLAT
SCREWS ON ONE SIDE
1.
Attach Part C to Part F by inserting
Hardware d into the pre-drilled holes and
rotating Part C clockwise, stopping when the
assembly is tight
3.
Place Part D into the pre-cut
slot and attach it using Hardware b
Please read entire instructions
before beginning
4.
Repeat Steps 1-2 for Parts B, C,
G & D
2.
Repeat Step 1 with Part A
5.
Loosen 2 of the seat slat screws
on one side of part E. Spread the
side rails of part E to insert the
bottom tenons of part I into their
slots as shown. Re-tighten the 2
screws in part E.
6.
Use 1of hardware b on each side
to fasten part I to part E.
3 CO-0400 Assembly

T25
c
x6
T20
H
a
x2
(Back and seat base not
shown for clarity)
7.
Lay the seat/back assembly from Step 5/6 on its side. Fix the assembly from
Step 1 to the seat/back assembly. Start by hand-tightening the two bolts (hardware
c) in the back leg. Next, hand-tighten the two bolts in the front leg. Then, hand-
tighten the two bolts through the middle back support up into the arm. Finally,
mechanically tighten all six bolts.
9.
Insert one tenon of part H into
one of the front legs. Applying some
pressure, flex the front leg to insert
the opposite end of part H into its
slot. Fasten using 2 of Hardware a.
8.
Lay the assembly from Step 7 on its opposite side and repeat the process to
attach the opposite leg/arm assembly to the chair.
4 CO-0400 Assembly