Breezesta PALM BEACH PB-1602 User manual

REV 00 - 7/19
PALM BEACH SQUARE TABLE/OTTOMAN
PB-1602
1 PB-1602 Assembly

A
B
D
C
ab
c
d
e
f
FOR USE IF CONNECTING
FURNITURE-SEE LAST
PAGE OF INSTRUCTIONS
PARTS
PART DESCRIPTION PART NO. QTY
A SIDE LEG ASSEMBLY SA-00364 2
B SQUARE TABLE TOP SA-00366 1
C SQUARE TABLE TOP RAIL ASSEMBLY SA-00402 2
D SQUARE TABLE SPREADER PRT-00789 2
SA-00395 HARDWARE KIT
PARTS DESCRIPTION PART NO. QTY
a #8 X 1-3/4" TORX SCREW H-0000-S8175 16
b #8 X 2-1/2" TORX SCREW H-0000-S825 22
c LEVELING MOUNT H-0000-LM 4
d 6-INCH T20 TORX BIT H-0000-T20X6 1
e CONNECTOR PLATE H-0000-CP 2
f #8 X 1-1/4 TORX SCREW-UNPAINTED H-0000-S8125 8
2 PB-1602 Assembly

A
C
D
a
D
C
A
a
B
b
c
1.
Attach the two side assemblies (
A
) to parts
C
and
D
.
Use hardware
a
, 2 at each end of items
C
and
D
). You
will need the 6" torx bit (
d
) to install the screws.
2.
Turn the table top assembly
B
upside down on a flat surface.
Turn the frame assembly from
step 1 upside down and slide it
over the table top. The
aluminum tube on the bottom of
the table should fit into the two
U-shaped sockets on the frame.
Using 22 of hardware
b
, fasten
the table top to the frame.
3.
Install leveling mounts
(hardware
c
) into the threaded
inserts on the bottom of the
frame.
3 PB-1602 Assembly

Optional:
If you wish to physically connect multiple pieces
of furniture together, use the included plates and 1-1/4" screws
(
e
&
f
) as shown at left. Connect plates to the inside faces of
the front and back legs allowing approximately 1-1/2" of the
plate to protrude from the side of the chair. Then move the
next furniture piece into place and fasten the plates to it.
4 PB-1602 Assembly