Brodit 739003 User manual

27 August, 2020, www.brodit.com, © 2020 Brodit AB
Product 739003
739003 Holder with lock. Passive holder with tilt swivel. For devices with original skin. With lock, 2 keys
included.
The holder with lock is to be used when you want to have your tablet safely locked in place and still easy
accessible, for example in shops, exhibitions, events, trucks, boats etc. The holder has a built-in lock, in order to
take the device out from the holder you need a key (2 keys included). You can connect e.g. a charging cable to
the device when it is in the holder.
The holder is mounted onto a tilt swivel. This mean you can easily adjust the angle for better viewing and switch
between portrait and landscape mode simply by turning the holder into desired position.
Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls.
ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and
GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm
fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard,
each combination of tablet-car must be examined in detail by you in order to determine if such an installation is
possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place,
as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations.
An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit
recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount.
EAN: 7320287390032
Item no 739003 fits:
Samsung Galaxy Tab Active 2. SM-T390/SM-T395 (For all countries)

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the
holder is firmly in place, but still can be adjusted.
2. To place the device in the holder: Place the lower part of the device into the holder where the opening between
the sidewalls is widest. Flip the upper part of the device forward so the device goes flat into the holder. Slide the
device straight downward into the holder. Press the block with the lock downward onto the upper part of the
holder and press the button to lock it.
3. To remove the device from the holder: Use the enclosed key to unlock the lock. Press the block upward away
from the holder. Press the device straight upward so the lower part reaches the widest part of the opening
between the sidewalls. Flip the upper part of the device away from the holder and lift the device out from the
holder.
4. The holder is in place.