BROSA Alpha Floor Lamp User manual

Alpha
Floor Lamp
A S S E M B LY GU I D E
V2

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 1 person.
And it's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Safety
1. For indoor use only.
2. Follow instructions carefully. Any deviations may be hazardous, or
void your warranty.
3. The external flexible cable or cord of this luminaire cannot be
replaced; if the cord is damaged, the luminaire shall be destroyed.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and
allow it to cool first. Then change the bulb, plug it in and switch it on.
6. This product is not suitable for children under 14 years of age.
7. Periodically check and re-tighten all screws and fasteners.
8. Switch off and wipe down your lamp with a clean cloth as needed.
9. Firmly secure all pieces. Small parts may present a choking hazard.
Notes:
1. Bulb is not included.
MAX.40W E27
220-240V ~ 50Hz

Components
HardwareHardware
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
A x 1 B x 1
②
③
③
①
Top Pole x 1
Middle Pole x 2
Base Pole x 1
Base x 1
Shade x 1
④
⑤

Step 1 Align a middle pole ③ with the top pole ② and firmly
screw them together. Repeat this for the other middle
pole ③ and then the base pole ④.
②
③
③
④

Step 2 Unscrew the bolt attached to the bottom of the pole
using the big Allen key A. Keep the removed bolt for
the following assembly.
A x 1
A

A x 1
Step 3 Fit the structure formed in Step 2 into the base ⑤
and adjust the base carefully to make sure the bulb
holder faces straight forward as shown in the Bird’s
Eye View.
Insert the bolt removed in Step 2 into the hole from
tho bottom of the base and tighten it with the big
Allen key A.
Bird’s Eye View
A
⑤

Step 4 Gently screw the correct bulb (not included) into the
bulb holder.

Step 5 Unscrew the bolt attached to the top of the stand
using the small Allen key B. Keep the removed bolt
for the following assembly.
B x 1
B

Step 6 Position the shade ① over the bulb. Make sure the
bracket inside the shade overlaps with the hole on
the top of the stand. Fix the shade into place with
the bolt removed in Step 5 and the small Allen key
B.
B x 1 B
①

Step 7 Place the completed product in its desired location.
Enjoy! We hope your new Alpha Floor Lamp lights
up your life!