Buffalo CT931 User manual

Model • Modèle • Modell • Modello • Modelo • Malli:
CT931
Crepe Maker
Instruction manual
CT931_UK_A5_v1_20190730.indb 1 2019/7/30 10:34

2
UK Telephone Helpline: 0845 146 2887
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove any
components on this product.
• Consult Local and National Standards to comply with the
following:
- Health and Safety at Work Legislation
- BS EN Codes of Practice
- Fire Precautions
- IEE Wiring Regulations
- Building Regulations
• Caution! Hot surface! Do not touch!
The temperature of cooking surface maybe high when the
appliance is operating.
• DO NOT immerse the appliance in water.
• DO NOT clean with jet/pressure washers.
• DO NOT move or carry the appliance when it is switched on.
• DO NOT leave the appliance unattended during operation.
• Always use oven gloves when cooking or carrying out any
adjustments to the appliance.
• Do not obstruct any ventilation openings in the appliance
body.
• During and after cooking, the unit is still hot. Never touch the
surface to avoid scalding.
• Always switch off and disconnect the power supply to the
appliance when not in use.
• This appliance must only be used in accordance with these
instructions and by persons competent to do so.
• Keep all packaging away from children. Dispose of the
packaging in accordance to the regulations of local authorities.
CT931_UK_A5_v1_20190730.indb 2 2019/7/30 10:34

3
UK
Telephone Helpline: 0845 146 2887
• If the power cord is damaged, it must be replaced by an
BUFFALO agent or a recommended qualified technician in
order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• Buffalo recommends that this appliance should be periodically
tested (at least annually) by a Competent Person. Testing
should include, but not be limited to: Visual Inspection,
Polarity Test, Earth Continuity, Insulation Continuity and
Functional Testing.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
• Buffalo Crepe Maker
• Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Installation
• Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials.
Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for
ventilation.
• Keep the unit away from splashing water and countertop’s edge.
Note: Before using for the first time, clean the appliance with warm soapy
water. Let dry completely.
CT931_UK_A5_v1_20190730.indb 3 2019/7/30 10:34

4
UK Telephone Helpline: 0845 146 2887
Operation
Storage tray
Hot plate
HEAT Indicator light
POWER Indicator light
Thermostat
Seasoning the Hot Plate
Before using for the first time the cooking surface needs to seasoned.
1. Ensure the cooking surface is clean.
2. Brush the surface with cooking oil.
3. Connect the appliance to the mains power supply. The POWER indicator light (green) turns on.
4. Set the thermostat to 50°C. The HEAT indicator light (orange) turns on.
5. Once the set temperature is reached, the HEAT indicator light turns off.
6. Turn the appliance Off and allow to cool before wiping away any excess oil.
7. The appliance is now ready for use. Repeat as necessary throughout the life of the appliance.
Making Crepes
1. Connect the appliance to the mains power supply.
The POWER indicator light (green) turns on.
2. Set the thermostat to the desired temperature
(50°C-300°C). The HEAT indicator light (orange)
turns On and the appliance begins to heat up.
3. When the set temperature is reached, the HEAT
indicator light turns Off.
4. Pour the required amount of batter mixture on to
the hot plate.
5. Spread the mixture in a circular motion around the
hotplate with a spreader [Fig. 1].
6. Cook on one side before flipping with a spatula to
cook the other side of the crepe.
7. Turning off: After use, set the thermostat to OFF
position and disconnect the appliance from power
supply.
1
CT931_UK_A5_v1_20190730.indb 4 2019/7/30 10:34

5
UK
Telephone Helpline: 0845 146 2887
Overheating protection
This appliance is featured with an overheat protection. Should the temperature exceed safe levels the
appliance will automatically cut off power.
The thermal Cut-out switch is located on the rear of the appliance. To reset the appliance after a sufficient
cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks, using a blunt pointed instrument.
3. The appliance is now reset and can be used as normal.
Cleaning, Care & Maintenance
• A BUFFALO dealer or qualified technician should carry out repairs if required.
• Always switch off the appliance, disconnect the power supply and allow to cool before cleaning or
performing maintenance.
• If necessary wipe the exterior with a soft cloth and warm soapy water.
• Dry thoroughly after cleaning.
Troubleshooting
If your BUFFALO appliance develops a fault, please check the following table before making a call to the
Helpline.
Fault Probable Cause Solution
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call BUFFALO agent or qualified Technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
Overheating protection is activated Reset the appliance
Technical Specifications
Model Voltage Power Current
Cooking
Surface
Diameter
Temperature
Range
Dimensions
h x w x d mm Weight
CT931 220-240V~
50/60Hz
3000W 13A 400mm 50ºC-300ºC 220 x 450 x 470 20Kg
CT931_UK_A5_v1_20190730.indb 5 2019/7/30 10:34

6
UK
Telephone Helpline: 0845 146 2887
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
change specifications without notice.
CT931_UK_A5_v1_20190730.indb 6 2019/7/30 10:34

DECLARATION OF CONFORMITY
• Conformiteitsverklaring • Déclaration de conformité • Konformitätserklärung • Dichiarazione di conformità •
• Declaración de conformidad • Declaração de conformidade
Equipment Type • Uitrustingstype • Type d'équipement •
Gerätetyp •
Tipo di apparecchiatura • Tipo de equipo • Tipo de equipamento
Electric Crepe Maker 3kW
Model • Modèle • Modell • Modello • Modelo • Malli
CT931
Application of Council Directives(s)
Toepassing van Europese Richtlijn(en) • Application de la/des
directive(s) du Conseil • Anwendbare EU-Richtlinie(n) •
Applicazione delle Direttive • Aplicación de la(s) directiva(s) del
consejo • Aplicação de directiva(s) do Conselho
Low Voltage Directive (LVD) 2014/35/EU
EN 60335-1:2012 + A11:2014
EN 60335-2-38:2003 +A1:2008
EN 62233:2008
Electro-Magnetic Compatibility (EMC) Directive
2014/30/EU
EN 55014-1:2006 +A1:2009 +A2:2011
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive
2011/65/EU
Producer Name • Naam fabrikant • Nom du producteur • Name
des Herstellers • Nome del produttore • Nombre del fabricante •
Nome do fabricante
Buffalo
Producer Address • Adres fabrikant • Adresse du producteur •
Anschrift des Herstellers • Indirizzo del produttore • Dirección
del fabricante • Morada do fabricante
Fourth Way,
Avonmouth,
Bristol,
BS11 8TB
United Kingdom
42 North Point Business
Park
New Mallow Road
Cork
Ireland
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and Standard(s).
Ik, de ondergetekende, verklaar hierbij dat de hierboven gespecificeerde uitrusting goedgekeurd is volgens de bovenstaande
Richtlijn(en) en Standaard(en).
Je soussigné, confirme la conformité de l'équipement cité dans la présente à la / aux Directive(s) et Norme(s) ci-dessus
Ich, der/die Unterzeichnende, erkläre hiermit, dass das oben angegebene Gerät der/den oben angeführten Richtlinie(n) und Norm(en)
entspricht.
Il sottoscritto dichiara che l'apparecchiatura di sopra specificata è conforme alle Direttive e agli Standard sopra riportati.
El abajo firmante declara por la presente que el equipo arriba especificado está en conformidad con la(s) directiva(s) y estándar(es)
arriba mencionadas.
Eu, o abaixo-assinado, declaro que o equipamento anteriormente especificado está em conformidade com a(s) anterior(es) Directiva(s)
e Norma(s)
Date • Data • Date • Datum • Data • Fecha • Data
18th June 2019
Signature • Handtekening • Signature • Unterschrift
Firma • Firma • Assinatura
Full Name • Volledige naam • Nom et prénom • Vollständiger Name •
Nome completo • Nombre completo • Nome por extenso
Ashley Hooper
Position • Functie • Fonction • Position • Qualifica • Posición • Função
Technical & Quality Manager
CT931_UK_A5_v1_20190730.indb 7 2019/7/30 10:34

CT931_UK_A5_v1_20190730
http://www.buffalo-appliances.com/
CT931_UK_A5_v1_20190730.indb 8 2019/7/30 10:34