BullFrog 2203 TIBOU User guide

ASSEMBLY AND INSTRUCTION MANUAL
www.bullfrog-design.com
MODEL 2203 TIBOU
© 2022 K URT BEI E R &KATI QU I N G E R
Motorised adjustable back Manually adjustable armrest Practical stool
Low back, smaller seat depth,
manually adjustable
High back, larger seat depth,
manually adjustable
Individual, flexible adjustment

2203 TIBOU
© 2022K URT BEI E R &KATI QU I N G E R
To adjust the head flap,
simply pull it forward or
push it backward.
Adjusting the head flap:
A B
12
2. Turn connector ratchet 1 of element A to the outside.
3. Firmly push together part A and B, until metal guides 2 catch into guides 1.
4. In case of dismounting li part B with the metal guides 2 and pull away.
Mounting of connectors
1. Position the elements at the place supposed to stay.

2203 TIBOU
© 2022K URT BEI E R &KATI QU I N G E R
Insert plug A into the charging socket B at the
back of the sofa/chair and then the transformer
into the socket.
Use of the charging socket:
With power supply unit: With battery:
Motorised back adjustment:
The back can be adjusted via remote control.
C
B
A
B
A
ATTENTION! TRANSFORMER
HAS TO BE SITUATED OUTSIDE
OF THE SOFA!
1. Fully charge the battery once before using
it for the first time. The charging time is
approx. 8 hours.
2. Insert plug A into the charging socket B at
the back of the sofa/chair and then the
transformer into the socket.
3. If the battery hums, the battery capacity is
too low. Please charge it immediately.
Attention! The battery must be recharged after
3 months at the latest, otherwise a deep
discharge could occur which would damage
the battery.
TRANSFORMER
Power supply

2203 TIBOU
© 2022K URT BEI E R &KATI QU I N G E R
Delivery condition: already synchronised November 2021
B
C
A
1. Press pairing buttons Aat receiver 2 x until the LED
indicates. The pairing process is active for about 10
seconds.
2. Press simultaneous button B and C at the transmitter
until the green LED at the receiver vanishes. This confirmes
a successful pairing process.
Note:
For the pairing prozess the distance between transmitter
and receiver should be less than 2 metres.
Motorised seat adjustment - Programming of transmitter and receiver
Transmitter
Receiver
LED
The programming is completed, the transmitter is now ready for operation. If the motor doesn´t start while
pressing, release the button and press again. If necessary retry the process.
Put drive systems into operation successively, don`t operate several systems simultaneous.
Otherwise the remote control cannot be assigned clearly by control/motor.
Brief instruction, Pairing-Method:
Should a new start-up of remote control be necessary the wireless communication with the control/motor
must be established. Proceed as follows:
Keep all documents relating to the purchase of your furniture carefully, even beyond the legal warranty period of 2 years. You will
find all important information in your product folder and also on our website www.bullfrog-design.com