BullFrog MODI 0220 User guide

Seat cushion continuously motorised
extendable to the relax position
Backrest manually adjustable to the
desired seat depth
Headrest to raise for comfortable
high-back comfort
www.bullfrog-design.com
25.06.2021
ASSEMBLY AND INSTRUCTION MANUAL
MODEL 0220 MODI
© 2020 K URT BEI E R &KATI QU I N G E R

0220 MODI
© 2020 K URT BEI E R &KATI QU I N G E R
Adjustment of headrest:
1. To adjust the desired position grip the headrest from the outside and lift it carefully upwards.
ATTENTION! DON`T SIT ON BACKS.
3. From zero position you can easily snap the headrest into desired position.
2. To obtain zero position pull the headrest carefully beyond the top position into your direction and fold down
into zero position.

0220 MODI
© 2020 K URT BEI E R &KATI QU I N G E R
Use of back function:
1. Reach under the back and pull it slightly upwards (into your direction) to move it forward.
Use of motorised seat adjustment:
The seat can be extended continuously by means of the remote control. See next page.
2. To obtain back rear position, reach under the back and push it back upwards with a slight movement.
Due to the seat and back function, there may be a slight noise when the seat is extended or retracted, depending
on the cover material.

0220 MODI
© 2020 K URT BEI E R &KATI QU I N G E R
A
Use of motorised seat adjustment:
1. Insert the plug A into the charging socket at the bottom of the sofa and then the transformer into the socket.
2. By pressing the switch buttons B and C at remote control, the seat can be moved continuously to the required
position.
Power supply
The charging socket is always located on the back opposite the arm section.
Plug ATTENTION!
TRANSFORMER HAS TO
BE SITUATED OUTSIDE
OF THE SOFA!
C
B
Charging socket
TRANSFORMER

0220 MODI
© 2020 K URT BEI E R &KATI QU I N G E R
Delivery condition: already synchronised December 2017
B
C
A
1. Press pairing buttons Aat receiver 2 x until the LED
indicates. The pairing process is active for about 10 seconds.
2. Press simultaneous button B and C at remote cont-
rol until the green LED starts to flash. The flashing confir-
mes a successful pairing process.
Note:
For the pairing prozess the distance between transmitter
and receiver should be less than 2 metres.
Motorised seat adjustment - Programming of transmitter and receiver
The programming is completed, the transmitter is now ready for operation. If the motor doesn´t start while pressing,
release the button and press again. If necessary retry the process.
Transmitter
Brief instruction, Pairing-Method:
Should a new start-up of remote control be necessary the wireless communication with the
control/motor must be established. Proceed as follows:
Receiver
LED
Put drive systems into operation successively, don`t operate several systems simultaneous. Otherwise the
remote control cannot be assigned clearly by control/motor.