BullFrog 0221 WUMMS User guide

www.bullfrog-design.com
Big sofa on a covered plateau Loosely inserted seat cushionsOptionally with motorised
seat adjustment
Luxurious with high quality
spring core
Type 62T
Type 258
Type 61T
Type 61TF
ASSEMBLY AND INSTRUCTION MANUAL
MODEL 0221 WUMMS!
© 2021 K URT BEI E R &KATI QU I N G E R

0221 WUMMS!
© 2021K URT BEI E R &KATI QU I N G E R
A B
12
2. Turn connector ratchet 1 of element A to the outside.
3. Firmly push together part A and B, until metal guides 2 catch into guides 1.
4. In case of dismounting li part B with the metal guides 2 and pull away.
Mounting of connectors
seam
zipper
FUNKI - how it works:
3. Now you are able to move the upper
part backwards until the upper part of
the cushion will click into place in the
zero position.
1. Take the cushion at its upper side and
put the cushion on your knees with the
zipper on the bottom. The seamless
side faces you.
2. Move the upper part of the cushion
towards yourself until the final position
is reached.
4. Now put the cushion in the preferred
position (e.g. in the back, seamless side
in front and zipper at the bottom). By
pulling the upper part of the chushion
towards yourself, you are now able
to choose among 16 raster positions,
however you like it.
1. Position the elements at the place supposed to stay.

0221 WUMMS!
© 2021K URT BEI E R &KATI QU I N G E R
Power supply
Attention!
Transformer has to
be situated outside
of the sofa!
A
C
B
Use of motorised seat adjustment:
1. Insert the plug A into the charging socket at the bottom of the sofa and then the transformer into
the socket.
2. By pressing the switch buttons B and C at remote control, the seat can be moved continuously to
the required position.
The charging socket is always
located on the back of the
connector side.
Charging socket
TRANSFORMER

0221 WUMMS!
© 2021K URT BEI E R &KATI QU I N G E R
Delivery condition: already synchronised November 2021
B
C
A
Motorised seat adjustment - Programming of transmitter and receiver
Transmitter
Brief instruction, Pairing-Method:
Should a new start-up of remote control be necessary the wireless communication
with the control/motor must be established. Proceed as follows:
The programming is completed, the transmitter is now ready for operation. If the motor doesn´t start while
pressing, release the button and press again. If necessary retry the process.
Put drive systems into operation successively, don`t operate several systems simultaneous.
Otherwise the remote control cannot be assigned clearly by control/motor.
Receiver
LED
1. Press pairing buttons A at receiver 2 x until the
LED indicates. The pairing process is active for
about 10 seconds.
2. Press simultaneous button Band Cat the transmitter
until the green LED at the receiver vanishes. This
confirmes a successful pairing process.
Note: For the pairing prozess the distance between
transmitter and receiver should be less than 2
metres.
The programming is completed, the transmitter is
now ready for operation. If the motor doesn´t start
while pressing, release the button and press again. If
necessary retry the process.