CR174: Front Bucket seats with Armrest without USB Port
Step#1 –Prepare seating
(Remove the headrest from seating by
pushing the button on the base.
Before installing the covers, unhook
the flap located behind the seat. The
flap is held in place by two pieces of
elastic with plastic clips. Push the clip
forward to unhook the clip this will
allow the material and straps
through.)
Step#2 –Install Backrest
(Apply the backrest adjusting the
material as you pull down so that the
seat aligns with the cover. Once the seat
cover is on push the material under the
headrest bases and in between back and
bottom. Push elastic and s-hooks through
the seating.)
Step#3 –Install Bottom Cover
(Place the cover over the bottom seat
making sure it aligns. Remove the straps
from the male buckle then tuck all
material and straps through the seating.
The side pieces are tucked into the
plastic housing.)
Step#4 –Attach buckles and hooks
(Pass the straps for the bottom cover
from rear to front. Once straps are
passed through, connect using the
buckles provided. Make sure all straps
are run OVER any wiring, mounts or
motors. The S-hooks attach to the coils
of the seat bottom.)
Step# 5 –Armrest and Headrest
(Turn armrest cover inside out about
halfway. Fold the armrest out at an
angle. After placing the armrest on, slip
the cover down the seating, slowly
unfolding the cover. The cutout for the
cover will align to the inside of the
seating. Apply covers on the headrest
with solid flap located on the front of the
headrest. The flap with the three-way
split is installed on the headrest going
from back to front. Adjust the material
accordingly and fasten the Velcro pieces.
The headrest can then be inserted back
into the seating.)
Enjoy your CalTrend Seat Covers
***In case of dirty or stained covers
hand wash with mild detergent and air
dry. NEVER MACHINE WASH OR DRY.
The material may come apart from
lamination or foaming. This will also
void any warranty.***
