KA120: Bucket Seating with removable Headrest
Step#1 –Prepare seating
(Remove the headrest from seating by
pushing the button on the base. Before
installing the covers, unhook the flap
located behind the seat. The flap is held
in place by two pieces of elastic with
plastic clips. Push the clip forward to
unhook the clip this will allow the
material and straps through.)
Step#2 –Install Backrest
(Apply the backrest adjusting the
material as you pull down so that the
seat aligns with the cover. Once the seat
cover is on push the material under the
headrest bases and in between back and
bottom. Push elastic and s-hooks
through the seat.)
Step#3 –Install Bottom Cover
(Place the cover over the bottom seat
making sure it aligns. Remove the straps
from the male buckle then tuck all
material and straps through the seating.
The side pieces are tucked into the plastic
housing.)
Step#4 –Attach buckles and hooks
(Pass the straps for the bottom cover
from rear to front. Once straps are
passed through, connect using the
buckles provided. Make sure all straps
are ran OVER any wiring, mounts or
motors. The S-hooks attach to the coils
of the seat bottom.)
Step#5- Headrest Installation
(Apply covers on the headrest with solid
flap located on the front of the
headrest. The flap with the three-way
split is installed on the headrest going
from back to front. Adjust the material
accordingly and fasten the Velcro
pieces. The headrest can then be
inserted back into the seating.)
Enjoy your CalTrend Custom Seat Covers.
***In case of dirty or stained covers hand
wash with mild detergent and air dry.
NEVER MACHINE WASH OR DRY. The
material may come apart from lamination
or foaming. This will also void any
warranty.***
