Canon CREATIVE PARK Bottlenose Dolphin User manual

Assembly Instructions
Before gluing, crease the
paper along mountain fold
and valley fold lines and
make sure rounded sections
are nice and stiff.
Glue, scissors and other
tools may be dangerous to
young children so be sure to
keep them out of the reach
of young children.
Scissors, set square, glue
( such as woodwork glue),
metal rod, spatula, a used
pen, toothpicks, tweezers
(useful for handling small parts).
Tools and Materials Assembly tip Caution
Make a mountain fold.
Mountain fold line
(dotted line) Cut line (solid line)
Cut out.
Valley fold line
(dotted and dash line)
Make a valley fold.
3. Use scissors to cut
along the solid line.
4. The pale-colored
numbers on the glue
tabs indicate the number
of the part to be attached
there.Use a spatula for
the small glue tabs.
1. Use a set square or
ruler and a dried up pen
to score along the dotted
lines, and fold along
them to make creases.
2. Work curves into the
pieces using a metal
rod before beginning
assembly. For small
pieces,add curves before
cutting them out.
Cut out
Cut these areas out.
*Read the Assembly Instructions carefully in page order referring to the page numbers on the parts list.
Assembly Instructions : Three A4 sheets
*It is easy to get pieces mixed up if you cut them all out at once, so just cut the pieces as you need them.
Parts list (pattern) :Five A4 sheets
Bottlenose dolphins are the most well-known type of dolphins. They
live in seas all over the world except those around the Arctic and
Antarctic Circles. They are 2-4 meters long and weigh between 150
and 650 kilograms.
Although they are rather small among marine mammals, they are
outstanding jumpers with great braking force. These master swimmers
can swim approximately 45 kilometers per hour in short bursts.
They are friendly and curious creatures who are thought to
communicate among themselves by letting out various sounds or
through body expressions.
*Red numbers are numbers of each respective part. Gray numbers are numbers of parts to be attached to red parts.
PAGE01
Bottlenose Dolphin : Assembly Instructions

Assemble Fin-b, and attach it to B02.
Assemble Fin-l and Fin-r,
and attach them to B01.
After attaching B01 and B02, attach the parts marked
in the green lines on B01 and B02 to close the body.
Then, attach by following the correct order
(refer to the green numbers).
Use a stick for areas where you cannot use your fingers.
Attach and assemble everything
except for the part marked in the
green line on B01 and attach to B02.
Assemble B02.
*There is no specific order for attaching glue tabs
without green attachment order numbers. However,
only attach them one at a time from either end
and not all at once.
curl
Attachment order.
glue
Glue tabs have been omitted from the diagrams to make them easier to understand.
PAGE02
Bottlenose Dolphin : Assembly Instructions

After assembling D01, D02, and D03, attach D04 on the bottom.
Then, attach D05 and D06 and place the completed dolphin on top.
Add and attach D02 and D03 to D01.
Assemble M02 and M03, and attach them to B01.
Add and attach M01 to B01.
Then, attach M01's glue tabs.
Assemble M01 and TFin-r,
and attach them to B04 and B05.
Curl B03 into a cylindrical
shape and attach to B02.
Curl B04 and B05 respectively
into a semi-conical shapes and
attach them to B03.
PAGE03
Bottlenose Dolphin : Assembly Instructions