Canon CREATIVE PARK Mobile Sky and Sea User manual

Mobile: Sky and Sea -Assembly Instructions-
This mobile depicts birds flying in the sky, and cute little fish swimming
in the sea.The arm that the string hangs from shows a day scene on
one side and a night scene on the other.
Have fun decorating your room with this playful, moving mobile!
Before cutting out the parts, use a ruler and exhausted pen (a pen that has run out of ink)
to score along the fold lines. Cut the parts out roughly first, then cut carefully along the
scissors lines after you have folded them. If you cut them out before folding them it may be
difficult to fold the edges neatly.
Use the base of the blade when cutting. Take care not to use the entire blade down to the tip,
as this makes it more difficult to control the cutting direction.
Turn the paper over and place it in the palm of your hand. Apply pressure to the rod and
move it left and right to curve the paper.
Fold the string in half and align the ends, then make a knot about 1cm from the end.
Use some scrap paper to create a pallet and spatula for the glue. This will ensure that you
don't use too much glue, and allow for a clean finish.
For parts that are glued together, place them between sheets of paper after gluing and then
pile something heavy like books on top. This will ensure a neat, flat finish.
Try it in the margin first, to test how hard you should press with the pen.
Be sure to put it in between scrap paper to keep your things clean from the glue.
Mountain fold (dotted line)
Make a mountain fold.
Glue spot
Glue together.
Scissors, a ruler, glue (we recommend woodwork glue),
string (any kind of fine, strong thread),
an exhausted pen (for scoring along fold lines),
a cylindrical rod (for curving parts)
Be careful that sharp corners or scraps of paper
do not poke or get in your eyes, etc.
Glue, scissors, strings and other tools may be
dangerous to young children so be sure to keep
them out of the reach of young children.
Valley fold (dashed and dotted line)
Make a valley fold.
Scissors line (solid line)
Cut along the line.
Cut in line (solid line)
Make a cut.
Assembly Instructions Tools and materials Caution
Folding paper
Curving paper
Applying glue
Tying strings
Gluing
paper together
Cutting out
with scissors

Use a ruler and exhausted pen to
score along the fold lines.
Put in between two sheets of paper, pile something heavy
such as books on top and leave to dry for a few hours.
Then, cut out the part.
Fold about 60cm of string in half and align the ends,
then make a knot about 1cm from the end.
Thread the ends through the loop as shown by the arrow.
Turn over and put glue on the side.
Add glue
Add glue Add glue Add glue
Mobile: Sky and Sea -Assembly Instructions-

Use a ruler and exhausted pen to
score along the center line.
Cut out the tab and the slot,
and put glue on one side of the tab.
Fold about 50cm of string in half and
align the ends, then make a knot about
1cm from the end. Thread the ends
through the loop as shown by the arrow.
Caution! Make sure that the awake
water bird sits on the bright water,
and the sleeping water bird sits on the dark water.
Put in between two sheets of paper,
pile something heavy such as books
on top and leave to dry for a few hours.
Then, cut out the part.
Turn over the water birds and put
glue on the area.
Cut out the water birds and arm parts.
Mobile: Sky and Sea -Assembly Instructions-
Open it up and put glue on the area.
Put in between two sheets of paper, pile
something heavy such as books on top
and leave to dry for a few hours.
Then, cut out the part.
Add glue
Add glue
Add glueAdd glue

Cut along the square line around the edge
of the torso parts, and make a mountain fold
along the center line.
Make sure these parts fit together exactly.
Put glue on the area and
attach the torso parts.
The gray area on the tips of
the wings should face up.
Fold about 25cm of string in half and align the ends,
then make a knot about 1cm from the end.
Thread the ends through the loop as shown by the arrow.
Turn over and glue.
Mountain fold
Valley fold
Put in between two sheets of paper, pile
something heavy such as books on top and leave
to dry for a few hours. Then, cut out the part.
Mobile: Sky and Sea -Assembly Instructions-
Mountain fold
Add glue

Mobile: Sky and Sea -Assembly Instructions-
Cut out the parts roughly,
and use a ruler and exhausted pen
to score along the lines.
Add a curve.
Add glue
Fold about 40cm of string in half and align the ends,
then make a knot about 1cm from the end.
Thread the ends through the loop as shown by the arrow.
Put glue on the glue spots and fins indicated
and attach the left and right sides together.
Turn over and curve.
Put glue on the back of the
lower half of the eye too.
Cut a slot.
Make a valley fold.
Reverse side
Reverse side Reverse side