Canon Creative Park Ford Convertible Cabriolet User manual

Classic Car Series : 02
Ford
Convertible Cabriolet
Assembly
Instructions
Mountain fold
Valley fold
Cut a notch
along this line.
Cut a notch
along the line.
Dotted line
Dashed and
dotted line
Solid line
Scissors mark
Fold so that the printed pattern faces outside. Dots indicate parts to be glued;
dotted lines indicate approximate area for
application of glue.
Glue parts with the same number together.
Glue areas within the same part together.
Glue to the reverse side of the specified part.
Fold so that the printed pattern faces inside.
Cut along the center of the line.
Red dot
Green dot
Blue dot
Glue reverse side to reverse side of other part.
Blue star
Glue, scissors and other tools may be dangerous
to young children so be sure to keep them out of
the reach of young children.
Assembly Instructions : Six A4 sheets (No. 1 to No. 6)
Build this model with careful reference to the Assembly Instructions.
ToolsAssembly tip
Key to symbols
Write the number of each part on the reverse side of the part in pencil upon
cutting it out, to be sure you can tell which part is which later.
Before gluing, crease the paper along mountain and valley fold lines. Trace
along the folds with a ruler and an exhausted ballpoint pen (out of ink) to get a
sharper fold.
Make sure rounded sections are nice and stiff.
Scissors
Ruler, set square
Glue (Wood glue or craft glue recommend)
Exhausted ballpoint pen (out of ink)
Toothpicks (for use in applying glue)
Tweezers (useful for handling small parts)
Pencil
View of completed model * This model was designed for Papercraft and may differ from the original in some respects.

Ford Convertible Cabriolet Assembly
Instructions
Align fold
lines and
flaps and
glue together.
Carefully shape curves.
Carefully shape curves.
Affix with glue.
Carefully shape curves. Affix with glue.
Glue at the last stage.
Shaded areas in diagrams indicate reverse side of parts.
Affix with glue.
Do not glue yet.

Ford Convertible Cabriolet Assembly
Instructions
Carefully shape curves.
Carefully shape curves.

Ford Convertible Cabriolet Assembly
Instructions
* Right side
Gently shape curves.
Carefully shape curves.
* Left side
* Note different numbers for left and
right parts.
* diagram is L
* Note different numbers for left and right parts.
* diagram is L

Ford Convertible Cabriolet Assembly
Instructions
Confirm top/bottom before gluing.
Carefully shape curves.
Fill the white part on the reverse side with a black marker.
Fill the white part
on the reverse side
with a black
marker.
Carefully shape curves.
Top
Top
Carefully shape curves.
Make sure up/down and front/rear are correctly aligned
before gluing. The side with a picture is the upper side,
and the side with folding line is the front side.

Ford Convertible Cabriolet Assembly
Instructions
Affix with glue.
Carefully shape curves. Pink flap indicates outer side.
Pink flap indicates outer side.
Joint should be positioned at the top.
Joint should be positioned at the top.
Confirm top/bottom before gluing.
Affix outer surface of tire like a bowl,
then wait until glue is dry before gently pulling
the tire into shape.
The joining part is
the lowest point.
The joining part is
the lowest point.
Affix all four tires, adjusting to
be sure they touch the ground.
Confirm top/bottom
before gluing.
Affix outer surface of tire like a bowl,
then wait until glue is dry before gently
pulling the tire into shape.
Arrow
indicates
'up'.
Arrow indicates 'up'.
Glue in order, - .
Glue in order, - .
Top
Top