Canon Paper Craft User manual

1
Pop-up Card (Christmas-tree) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
Caution:Glue, scissors, and other tools may be dangerous to young
children so be sure to keep them out of the reach of young children.
Valley fold
(dashed and dotted line)
*Make a valley fold.
Scissors line(solid line)
*Cut along the line.
Cut in line(solid line)
*Make a cut.
Black triangle
Glue here
Mountain fold(dotted line)
*Make a mountain fold.
Assembly Instructions
scissors, paste, a used ballpoint pen (tracing along the fold lines
makes them easier to fold)
You will needYou will need
White triangle
Glue the back
Stick the base cards together.
Cut out the parts and crease them along the fold lines indicated.
Front cover
Back cover
Stickers
Base Base
Front cover Tree

2
Pop-up Card (Christmas-tree) : Assembly Instructions
Canon is a registered trademark of Canon Inc.
Turn assembly 3 over, match up the tree assembly 5 with the tree shape on the base
card and add glue to the glue spot. Add glue to the other glue spot while folding.
Turn assembly 2 over and stick on the back cover.
*Stick on from the inside in order to match up properly with the tree-shaped cutaway.
Line up the tree with the back sheet and add glue to the point circled in red only.
Use a paper punch to make holes in the tree assembly 4 at any spot you like.
If you don't have a paper punch, stick on the attached stickers.
Line up the corners of the two cover sheets and glue the sheets together so that
they are pinched between the glue spots.
Glue assembly 7 to the back of the left hand side of assembly 6, and you're done!
* Be careful to stick on the assembly facing the right way!