Canon CREATIVE PARK Pop-up Card (Halloween / Black cat &... User manual

Pop-up Card (Halloween / Black cat & Witch) : Assembly Instructions
Katsuyuki Shiga(PinoArt) Canon Inc.
Page
Notation Key
Scissors
Paste, or woodwork glue
Stencil pen, or bodkin
Ruler
Scissors line
Mountain fold
Valley fold
Glue spot
Tools
Numbers of parts
to be attached
Parts No.
Glue reverse side
Assemble the card
Use pattern: Page2, Page3.
Cut out A1 by cutting along the lines.
Cut along the line marked .
Scissors line
Mountain fold
Parts No. / Parts name
Make a mountain fold on A1.
Trace along the mountain fold line with a stencil pen, scoring it
to make it easier to fold.
Using the photo as a guide, attach in the direction of the arrow.
Attach A1 and A2, and the card is complete.
Check that A1 and A2 are the right way up,
place some paste on the blue area of the
back side, and attach them together.
The Assembly instructions are divided into three blocks:
A (Card), B (Jack-o'-lantern) and C (Decorations, Black cat and
Witch ).
Follow the instructions for each block to assemble your card.
<Caution>
Keep scissors and glue away from small children.
Be careful not to cut your fingers when using scissors.

Attach the Jack-o'-lantern and the joint together.
Attach the Jack-o'-lantern and B21 to the card, and your
Jack-o'-lantern is complete.
Pop-up Card (Halloween / Black cat & Witch) : Assembly Instructions
Katsuyuki Shiga(PinoArt) Canon Inc.
Page
Make the jack-o'-lantern
Use pattern: Page4, Page5.
Assemble B1, and attach parts B2 through B9.
Assemble B10, and attach parts B11 through B14.
Attach the parts from B15 to B20.
Cut out the triangle shaped part. Add curves to these parts.
Add curves to these parts.
Attach the areas
indicated in blue.
Assemble
in the same way.
Attach the areas
indicated in blue.
Attach the areas
indicated in blue.
Close and glue together.
After attaching the parts, open and close to check if the card
opens smoothly.
Put glue on this part first.
Open and close to check that it moves. Add a curve.

Pop-up Card (Halloween / Black cat & Witch) : Assembly Instructions
Katsuyuki Shiga(PinoArt) Canon Inc.
Page
Make the decorations, black cat and witch
Use pattern: Page6, Page7.
Attach C1 to the card and Jack-o'-lantern.
Glue C2 and C3 to the card and C1.
Attach the parts from C4 to C7.
Close and glue together. It attaches here.
Attach the areas indicated in blue.
Attach the areas indicated in blue.
Attach the parts from C8 to C10.
Attach the black cat and witch to the card, and you're done!
Attach the areas indicated in blue.
Attach the areas
indicated in blue.
The folds may not be exactly on the lines,
depending on how your card is glued.
The folds may not be exactly on the lines,
depending on how your card is glued.