Canon Paper Craft Tower Bridge England User manual

Assembly Instructions
Mountain fold(dotted line)
Make a mountain fold.
Valley fold(dashed and dotted line)
Make a valley fold.
Scissors line(solid line)
Cut along the line.
Cut in line(solid line)
Cut along the line.
Glue spot(Red dot)
Glue parts with the same number together.
Glue spot(Green dot)
Glue within the same part.
Glue spot(Blue dot)
Glue to the rear of the other part.
Glue
The glue spot(colored dot)
shows where to apply the glue.
Tools and materials
Assembly tip
Caution
Scissors, set square, glue(We recommend stick glue), pencil, used
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
fold lines and make sure rounded sections are nice and stiff.
Glue, scissors and other tools may be dangerous to young children
so be sure to keep them out of the reach of young children.
View of completed model
Assembly Instructions:Four A4 sheets(No.1 to No.4)
*This model was designed for Papercraft and may differ from the original in some respects.
*Hint: Trace along the folds with a ruler
and an exhausted pen (no ink) to get a sharper, easier fold.
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Before starting assembly:Writing the number of each section on its back side before cutting out the sections is highly
recommended.
(* This way, you can be sure which section is which even after cutting out the sections.)
How to move the bridge girders: When this model is finished, you can move the bridge girders.
Make sure the latch is open. Depress the lever on the side. Close the latch.
Tower Bridge, England: Assembly Instructions Canon ®is a registered trademark of Canon Inc. ©Canon Inc. ©T.Ichiyama
http://www.canon.com/c-park/en/

Tower Bridge, England: Assembly Instructions
Indicates where sections should be glued together.
Glue
before cutting.
Glue
before cutting.
Wrap around.
Wrap around.
* Build two sets of all the parts on sheets 5 and 6. Make sure part 9 is correctly oriented.
Position
the interior side vertically.
Fold inward so that the printed
surface is on the inside.
Canon ®is a registered trademark of Canon Inc. ©Canon Inc. ©T.Ichiyama

Tower Bridge, England: Assembly Instructions
* Build two sets of all the parts on sheets 7 and 8.* Build two sets of all the parts on sheets 5 and 6.
Position in place at the opening.
At this time, adjust the bridge to minimize distortion.
Be careful to ensure parts
18 and 19 do not protrude!
Check to make sure
the bridge can move when
attaching the bridge girders.
Glue in place so that the part shown
in the illustration protrudes.
Make sure parts 26 and 27 are correctly oriented
The cut end is straight
The cut end features a notch
Canon ®is a registered trademark of Canon Inc. ©Canon Inc. ©T.Ichiyama

Tower Bridge, England: Assembly Instructions
* Build two sets of all the parts on sheets 7 and 8.
Make sure the parts are
correctly oriented.
Parts 34 and 35 are
attached to the interior side.
Make sure the parts are correctly oriented.
Double-decker bus
Finished!
Canon ®is a registered trademark of Canon Inc. ©Canon Inc. ©T.Ichiyama