Canvas Bala Corner Chair KVS948D User manual

ASSEMBLY INSTRUCTIONS
Toll-free: 1-888-670-6684
IMPORTANT: Please read this manual carefully before beginning assembly of this product.
Keep this manual for future reference.
BALA
PRODUCT NO. KVS948D
MODEL NO. 088-2042-0
SECTIONAL CORNER CHAIR

Imported for Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8
Made in Vietnam

3
3
Table of Contents
Important Safety Instructions
Parts List
Assembly
Cleaning and Maintenance
Technical Data
Warranty
4
5-7
8
8
9
3
Warning! To reduce the risk of serious injury, read the following safety
instructions before assembling and using the corner chair.
• This product is intended for domestic outdoor use only.
• The product should be placed on flat horizontal ground.
• Any assembly or maintenance of the product must be carried out by adults only.
• Arrange necessary manpower when assembling or moving the product.
• Some parts may contain sharp edges. Wear protective gloves if necessary.
• Keep children and pets away while setting up the corner chair.
• Check all of the nuts and bolts periodically for tightness. When required, tighten
them again.
• Repairing and replacing parts should be done by a qualified technician.
• Use the correct bolts as indicated. Do not tighten any of the bolts until the corner
chair. is completely assembled.
•
Do not discard of any of the packaging until you have checked that you have all of
the parts and fittings required.
• Children should always be under direct adult supervision while using this product.
• Retain these assembly instructions for future reference.
Caution! Always keep children under close supervision while they are using or are
around this product.
Never leave children unattended.
TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: Retain for future reference and read carefully.

4
PARTS LIST
PRODUCT NO. KVS948D｜MODEL NO. 088-2042-0
F
10 mm Wrench - 1
E
Torque Wrench - 1
D
4 mm Hex. Screw - 1
C
M6xP1.0 mm Plastic Nut - 7
B
D6.5xD13x1.0 mm Washer - 7
A
M6x55 mm Bolt - 7
6
Seat Cushion - 1
5
Right Back Cushion - 1
Left Back Cushion - 1
4
3
Seat Assembly - 1
2
Back Assembly - 1
1
Arm Assembly - 1

• Proper placement of your corner chair is essential.
• Do not place the product underneath electrical lines.
• Keep children away during assembly.
• This product contains small parts which can be swallowed by children.
• Keep fingers away from the places where they can be pinched or trapped.
• Do not attempt to assemble the corner chair if any parts are missing.
ASSEMBLY
5
CAUTION!
Let us help you!
DO NOT RETURN YOUR PRODUCT TO THE STORE. CALL US FIRST!
1-888-670-6684
or have damaged or missing parts, please call our customer service
toll-free helpline. Contact us for assistance, we’re here to help.
Please read and understand this manual before any assembly. Before beginning
assembly of product, make sure that all parts are present. Compare parts with the parts list. If
any part is missing, or if you have any questions, contact the service centre at
1-888-670-6684 (toll free).
Place all of the parts from the box in a cleared area and position them on the floor in front of
you. Remove all packing materials and place them back into the box. Do not dispose of the
packing materials until assembly is complete. Read each step carefully before beginning any
assembly and make sure that you understand each step. If you are missing a part, please call
our toll-free number for assistance 1-888-670-6684.
Needed for assembly:
IMPORTANT:
If you have questions regarding your product, require warranty assistance,
2 people
Torque Wrench "E" + Hex Screw "D"
D
E

6PRODUCT NO. KVS948D｜MODEL NO. 088-2042-0
ASSEMBLY
3
Step 1
Requires: 1, 2, A, B, and C
Place the back assembly 2onto a non-abrasive surface, such as a carpet.
Fasten the arm assembly 1to the back assembly 2by using bolts A,
washers B, and plastic nuts C. Do not tighten bolts.
Step 2
Requires: 1, 3, A, B, and C
Fasten the seat assembly 3to the back assembly 1by using bolts A,
washers B, and plastic nuts C. Do not tighten bolts.
A B C
A
C
B
1
1
2
A
C
B
A B C
A
B
A
C
C
B

7
5
4
6
Step 3
Requires: 2, 3, A, B, C, D, E, and F
Fasten the seat assembly 3to the back assembly 2by using bolts A,washers B,
and plastic nuts C.Secure all of the bolts by using wrenches D, E, and F.
Make sure that all of the bolts have been tightened completely.
Step 4
Requires: 4, 5, and 6
Turn the chair to an upright position. Place cushions 4, 5, and 6onto
the chair.
3
2
A
C
B
A
C
B
G
A B C
D E F
Please use the clips to connect and secure each
section together. Use of the clips is optional and
dependent upon the user's personal preference.
Securing Clips
WARRANTY

CLEANING AND MAINTENANCETECHNICAL DATA
Dimensions (LxWxH)
Product weight
CAUTION!
• Wash frame and wicker parts with mild soap and water, rinse thoroughly, and dry completely.
Do not use bleach, acid, or other solvents on the frame or wicker parts.
• The cushions may be washed on the surface only by using mild soap and water or
commercial foaming upholstery cleaner if necessary. If washed, rinse well and hang to dry.
Do not machine wash or dry.
• We recommend the use of furniture covers when not in use.
• Inspect and tighten all of the bolts and fasteners on a regular basis to ensure proper
performance and safety of your chair.
• In order to prolong the life and beauty of your corner chair, we recommend that it be stored
in a dry and protected area during off season periods.
8PRODUCT NO. KVS948D｜MODEL NO. 088-2042-0
73 x 73 x 76 cm
16 kg
28 3/8 x 28 3/8 x 29 15/16"
35 lb 4 oz
• Check all of the screws and nuts periodically for tightness, fastening them again as required.
• Disassemble the chair in the reverse order of the assembly steps. Always disassemble
the chair completely. A partially disassembled chair is not stable enough to resist wind
and bad weather, and therefore can be damaged and/or cause damage.
• Clean the chair with mild soap and water. Rinse thoroughly, and wait until the product
is dry before reassembling it.

9
WARRANTY
This Canvas product carries a five (5) year warranty against defects in
workmanship and materials.Trileaf Distribution agrees to replace the
defective product free of charge within the stated warranty period, when
returned by the original purchaser with proof of purchase.This product is
not guaranteed against breakage due to misuse and/or abuse.
TM/MC

ASSEMBLY INSTRUCTIONS
Toll-free: 1-888-670-6684
IMPORTANT: Please read this manual carefully before beginning assembly of this product.
Keep this manual for future reference.
BALA
PRODUCT NO. KVS948G
MODEL NO. 088-2042-0
SECTIONAL ARMLESS CHAIR