Canvas CV Camrose 088-2208-8 User manual

Production Number: xxxxxxxx
ASSEMBLY INSTRUCTIONS
Toll-free: 1-888-670-6684
IMPORTANT: Please read this manual carefully before beginning assembly of this product.
Keep this manual for future reference.
CAMROSE
7-PIECE FIRE TABLE DINING SET
MODEL NO. 088-2208-8
PRODUCT NO. A208005504

WARNING: For Outdoor Use Only.
DANGER
If you smell gas:
2. Extinguish any open flame.
odour
property
flammable vapours
shall
odour.
3.
1 AA 1.5V battery required (not included)
CAUTION: Rechargeable batteries contain
nickel-metal hydride and must be recycled
or disposed of properly. Do not mix old and
new batteries. Do not mix alkaline, standard
(carbon-zinc), or rechargeable batteries. Do
not dispose of batteries in fire. Batteries may
explode or leak. The battery cannot be ingested.
WARNING:
DANGER
CAMROSE 7-PIECE FIRE TABLE DINING SET
Propane cylinder required (not included)

3MODEL NO. 088-2208-8 | PRODUCT NO. A208005504
TABLE OF CONTENTS
GENERAL INFORMATION
General information
Specifications
Important safety information and precautions
Expanded view
Parts list
Assembly
Location
Setup
Gas connection
Leak test
Lighting
Storage and maintenance
Troubleshooting
Limited warranty
by
carbon monoxide
Technical data
3
4
4
6
7
19
20
19
20
21
18
9
18
18
IMPORTANT
Please take time to read these instructions thoroughly and follow each step carefully for safe and easy
operation. Keep this manual for installer and consumer future reference/use. We would like to hear from
you with any comments or suggestions.
21
to use only

Product name
Model No.
Rated Heat Output
Fuel
Gas Supply
Manifold Pressure
Orifice Size (diameter)
Gas Supply Pressure
Camrose 7-Piece Fire Table Dining Set
4
SPECIFICATIONS
IMPORTANT SAFETY INFORMATION AND PRECAUTIONS
Propane—LP
20 lb (9 kg) LP-Gas cylinder
11" W.C.
1.9 mm
25 PSI (minimum) to 250 PSI (maximum)
The installation must comply with local codes, or in the absence of local codes with the
National Fuel Gas Code, ANSI Z223.1/NF-PA54; the International Fuel Gas Code, Natural Gas
and Propane Installation Code, CSA B149.1; or the Propane Storage and Handling Code, B149.2,
as applicable.
The LP gas supply cylinder to be used must be:
1-Constructed and marked in accordance with the U.S. Department of Transportation (D.O.T.)
Specifications for LP-Gas Cylinders, or the Standard for Cylinders, Spheres and Tubes for
Transportation of Dangerous Goods and Commission, CAN/CSA-B339 as applicable;
2-Provided with a listed overfilling prevention device;
3-Provided with a cylinder connection device compatible with the connection for the appliance.
Always place the appliance on a firm and level surface.
Solid fuels must not be burned in this gas appliance. When using decorative lava rocks, use
only lava rocks (INCLUDED).
The appliance must be used only outdoors in a well-ventilated space and not be used in a
building, garage or any other enclosed area.
When in use, keep the appliance area clear and at least 40" (101.6 cm)
side, back and top
clearance from combustible materials, gasoline and other flammable liquids .sruopavdna Do
not use the appliance under overhead combustible surfaces. Certain items or materials, when
stored under the appli ance or nearby, will be subjected to radiant heat and could be damaged.
088-2208-8 A208005501
38,000 BTU/HR

5 MODEL NO. 088-2208-8 | PRODUCT NO. / &##"
IMPORTANT SAFETY INFORMATION AND PRECAUTIONS
Open the door and inspect the hose assembly and burner prior to each use. If there is evidence of
excessive abrasion or wear or if the hose or burner is damaged, it must be replaced by an
appropriate part from the manufacturer.
Inspect the gas connections of the appliance prior to each use. Do not operate the unit if there is
a gas leak. Have the appliance inspected annually by a qualified service person.
The pressure regulator and hose assembly provided with the appliance must be used. The replace-
ment part must be the same as the part specified by the manufacturer.
For instructions on how to connect the LP-Gas tank and check for leaks, please refer to “Gas Connection”
on page 18 and “Leak Test” on page 19.
Children and adults should be alerted to the hazards of high surface temperatures and should stay
away to avoid burns and prevent clothing ignition.
Young children and pets should be carefully supervised when they are in the area of the appliance.
Any guard or other protective device removed for servicing the appliance must be replaced prior
to operation.
Clothing or other flammable materials should not be hung from the appliance or placed on or near
the appliance.
Do not use this appliance if any part has been under water. Immediately call a service technician to
inspect the appliance and to replace any part of the control system which has been under water.
The LP-Gas supply cylinder to be used must be constructed and marked in accordance with the specifi-
cations for LP-Gas cylinders of the U.S. Department of Transportation (DOT).
The cylinder supply system must be arranged for vapour withdrawal and the cylinder must include
a collar to protect the cylinder valve.
Use only 20 lb (9 kg) LP-Gas cylinders.
Do not burn wood or any other materials in this appliance.
The appliance must be isolated from the gas supply piping system by closing its individual manual
shutoff valve during any pressure testing of the gas supply piping system at test pressure equal to
or less than 1/2 PSI (3.5 kPa).
Other cylinders may be acceptable for use with the appliance provided they are compatible with
the appliance retention means and accompanied by illustration(s) depicting the cylinder mounted on
the appliance using the cylinder retention means and the point of contact between the cylinder and
the retention means.
Properly place the hose out of pathways where people may trip over it or in areas where they may
be subject to accidental damage.
The burner must be replaced prior to the appliance being put into
operation if it is clear that the burner is damaged. The replacement
burner must be the same as the part specified by the manufacturer.
To clean the appliance, including the burner, please refer to “Storage
and Maintenance” on page 20.
18" (46 cm)
12 1/2" (32 cm)

6
EXPANDED VIEW
EXPANDED VIEW

PARTS LIST
7MODEL NO. 088-2208-8 | PRODUCT NO. / &##"
Parts List
Label Part Number Description Qty Part Image
A P003100067 Lid 1
B P002100225 Top 1
C P002500092 Bowl 1
D P002400030 Back panel
Pre-assembled 1
E P004100085 Accessory for
door 1
F P002400032 Side panel 1
G P002400031 Panel
Pre-assembled 1
H P006700047 Cylinder rack 1
I P006600020 Lava rock (1
kg) 4
J P005100108 Chain
Pre-assembled 2
K Foot tube 1
L Support 4
3
3

If you want to replace the parts listed, please contact Customer Service Centre: 1-888-670-6684
8
Hardware Pack
Label Part Number Description Qty Add Part Image
AA H010020011 Bolt M6*15 31 4
BB H050030001 Flat washer
M6 31 4
CC H090010017 Wrench M6 1 0

9MODEL NO. 088-2208-8 | PRODUCT NO. / &##"
ASSEMBLY

1x
2x
4x 4x

ASSEMBLY

1x
4x 4x
2x

ASSEMBLY
11 MODEL NO. 088-2208-8 | PRODUCT NO. A208005504
3
1x
4x 4x
NOTE:
Do not tighten screws all
the way until you have
assembled the footrest.
Once assembly is complete,
tighten each screw.
7DNHWKHGRRUDZD\

ASSEMBLY
1

1x 1x
3x 3x

ASSEMBLY
13 MODEL NO. 088-2208-8 | PRODUCT NO. A208005504
5
4x 4x
NOTE:
Do not tighten screws all
the way until you have
assembled the body.
Once assembly is complete,
tighten each screw.

ASSEMBLY
14
4x 4x
NOTE:
Do not tighten screws all
the way until you have
assembled the body.
Once assembly is complete,
tighten each screw.

ASSEMBLY
15 MODEL NO. 088-2208-8 | PRODUCT NO. / &##"

1x
4x 4x
1x


4x 4x
ASSEMBLY
16
NOTE:
Do not tighten screws all
the way until you have
assembled the table.
Once assembly is complete,
tighten each screw.


ASSEMBLY
17 MODEL NO. 088-2208-8 | PRODUCT NO. / &##"
,QVWDOOWKHGRRU

1&
ASSEMBLY

1x 1x

Your gas appliance must be installed on a flat, stable surface, away from any
combustible materials or construction.
1-Remove the appliance from container box and place it on any level, outdoor,
non-combustible surface.
NOTE: Do not place this appliance on grass or dirt area. This may prevent proper
safety venting.
2-Open the gas door and put the cylinder inside.
LOCATION
SETUP
GAS CONNECTION
Your gas appliance comes assembled, ready for a gas connection.
3-Unscrew the battery box as shown in Fig. 1. Insert the negative electrode side of the
battery into the bottom of battery box as shown in Fig. 2. Then screw the battery box as
shown in Fig. 3.
Fig. 1 Fig. 2 Fig. 3
77 8
1)
2)
( 9 and the safety information on page 5).
)
).
)
1MODEL NO. 088-2208-8 | PRODUCT NO. A208005504

Do not use an open flame to check for leaks.
Do not smoke during testing.
Do not test indoors.
A leak test must be performed whenever the gas cylinder is replaced.
WARNING!!!
NOTE: While in use, the burner flame should be mainly blue in appearance with a small
amount of yellow. The flame can be identified by the following figure.
1. Make sure the control knob is in the “OFF” position.
2. Make sure the gas cylinder is correctly and securely connected to the pressure regulator,
without over-tightening.
3. Turn on the gas cylinder valve. Apply 50% soap and 50% water solution to the gas hose
and connections between the control knob and gas cylinder.
4. If gas is leaking, you will see bubbles form. In case of leaks, turn off the gas supply,
undo the leaking connection, re-connect it and try again. If the leak persists, consult
Customer Service Centre for assistance at 1-888-670-6684.
5. If the connection does not leak, continue to the next step.
1. Push in and turn control knob to LOW.
2.
If the burner is not lit, turn the knob back to "OFF". ait 5 minutes
3.
If burner is lit, continue to depress control knob for 1–2 minutes
until the thermocouple is hot.
4. Release control knob and the burner should stay lit.
5. Turn control knob to desired heat setting: LOW – HIGH.
6.
LEAK TEST
LIGHTING
LEAK TEST
Turn control knob to OFF to shut down. Turn off gas supply at
cylinder. Allow a 5-minute complete shut-off period before
relighting the appliance.
and repeat step 1.
Press and turn the control valve knob clockwise to OFF to shut down the fire pit.
Close the gas cylinder valve when the fire pit is not in use.
(CAUTION: Do not kink flexible gas hose. If it is kinked, a gas leak could occur.)
7.
Warning: Lighting the fire table improperly could lead to an unsafe condition.
BLUE
BLUE
LOW
HIGH
YELLOW TIPS
LOW
Correct Flame
Incorrect Flame
2))
+,*+
0$;
%$6
$55(7
/2:
