Clarke CSR5150 User manual

SHELF UNIT
Decide on the position you require the bottom shelf to be.
Fit one short shelf support between the two leg angles.
Repeat this again making sure that the same short shelf support is at
the same height.
Now fit the two long shelf supports matching the two short shelf supports.
Always hammer gently, being sure the shelf support tabs are in
line with the leg angle slots.
If the tabs are out of line, simply bend them to line up either
way to suit.
Do not use force and damage the tabs.
When hammering the shelf supports, always hammer the surface
closest to the angle.
ASSEMBLY INSTRUCTIONS
PARTS INVENTORY CHECKLIST
Shelves ............................................... 5
Short Shelf Supports ......................... 10
Long Shelf Supports . ........................ 10
Angle Leg Sections ........................... 8
Plastic End Protectors........................ 16
Angle Leg Corner Spacers ................ 4
Connecting Plates ............................8
Nuts and Bolts ................................... 4
Please read these instructions
before assembly.
CAUTION: Due to the sharp metal
edges, suitable protective gloves
should be worn during assembly.
TOOLS NEEDED FOR THE JOB
• A hammer or a mallet
• A screwdriver and 10mm spanner (corner
bench only)
Model No: CSR5150 - Max rated load150kg per shelf (evenly distributed)
Part Nos: 6600504 (silver), 6600516 (black), 6600506 (red),
6600508 (blue), 6600520 (galvanised)
Model No: CSR5350 - Max rated load 350kg per shelf (evenly distributed)
Part Nos:6600510 (silver), 6600518 (black), 6600512 (red),
6600514 (blue), 6600522 (galvanised)
GC0616
CSR 5150 Dims (WDH);-Shelving 800x300x1500mm/Bench Layout 1600x300x750mm.
Product weight 16.7kg
CSR 5350 Dims (WDH);-Shelving 900x400x1800mm/Bench Layout 1800x400x900mm.
Product weight 27.8kg
1

Position the shelves
on the shelf supports
after full assembly.
34
5
6
7
Clarke International, Hemnall Street, Epping, Essex CM16 4LG: Parts & Service - Tel: [phone]
Fit the plastic protectors
provided to the end of each leg.
For assembly as a 5-shelf unit,
join the upper and lower leg sections
together using the connecting plates.
The middle shelf may be fitted at any
position close to the joint between top
and bottom leg.
Repeat this at the other end, then fit
the long shelf supports.
Assembling as a standard bench
Refer to Step I and Step 2, assemble as
shown, bolting the two frames together with
the nuts, bolts and spacers supplied, then
position the four shelves as in step 3.
IMPORTANT...
• Never exceed the maximum loading for your shelving unit.
(CSR5150-150kg per shelf/ CSR5350-350kg per shelf)
• The load must be evenly distributed across the shelves.
• Your Hammer-Fast shelving should be fastened to the wall where possible with
suitable fasteners (not included).
• Always place heavier items on the lower shelves.
Assembling as a corner bench
The same assembly instructions apply as Step
6 except you bolt the bench together at right
angles as illustrated.
Fit another two short shelf supports at the desired height,
then fit the two long shelf supports to match the short
shelf supports.
2