Comeup Seal Gen2 9.5 User manual

Replace T type clutch kit with Air clutch
Seal Gen2 9.5/12.5
Using a 4mm Allen wrench, remove
the four M5 socket head cap
screws holding the brake cover to
the gear housing.
1
Using a 3mm Allen wrench, loosen
the M6 socket set screw securing
the clutch T-handle threads in the
gear housing.
2
3Remove the T-handle from the gear
housing.
-1-

Seal Gen2 9.5/12.5
Rotate the air clutch assembly
counter clockwise to locate the air
port in the desired orientation. Do
not unscrew the air clutch assembly
more than one full revolution to
orient the air port.
Using a thin 32mm wrench
(supplied with the air clutch) tighten
the jam nut against the gear
housing.
5
-2-
Using a 3mm Allen wrench, tighten
the M6 socket set screw securing
the clutch mechanism threads into
the gear housing.
6
Make sure the 32mm jam nut is
threaded to the top of the threads of
the air clutch assembly (PN:
883036).
Thread the air clutch assembly
completely into the gear housing.
4

Seal Gen2 9.5/12.5
-3-
Reinstall the brake cover and
secure using the four M5 socket
head cap screws removed in step 1
using a 4mm Allen wrench.
7
When installation is complete, the
position of air clutch is shown as
picture.
8
COMEUP Industries Inc.
No.139, Jieyukeng Rd.,
Ruifang Dist.,
New Taipei City 22453, Taiwan
Tel: [phone]
Fax:[phone]
Mail: [email protected]
www.comeupwinch.com Stand: 7.1.2019
Version: 00