Confer Plastics 6000 User manual

Retro Fit Barrier Kit
Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100
Parts List
4 - #10 x 1-1/4” Sheet Metal Screw
1 – Upper Brace
1 – Lower Base
1 – Small Barrier Section
1 – Large Barrier Section
1 – Strip of 4 Foam Pads
Ladder must be assembled according to Instructions before installing Barrier Kit. Ladder must be
removed from Swimming Pool before installing Barrier Kit.
1. Snap Small and Large Barrier Sections into slots
on Lower Base as shown.
2. Separate Barrier sections at the top slightly and position Upper Brace over Small Barrier
Section. Next, spread the “fingers” on the Upper Brace and slide into position on the Large
Barrier Section.
See other side

Retro Fit Barrier Kit
Barrier Kit for Ladder Models #6000, #6100, #7000 and #7100
3. Place the Base and Brace into position, centered, on the bottom and fourth treads of the ladder.
Install the 4 #10 x 1-14 screws on a slight angle as shown, first in the Upper Brace, and then in the
Lower Base.
4. Install the self-adhering foam strips to the Large
Barrier Section as shown. Finally, install the Ladder
in the Swimming Pool according to the Instructions provided
with the Ladder.
Note: Barrier sections must be filled with water to prevent
floating.
CONFER PLASTICS, INC.
97 WITMER ROAD
NORTH TONAWANDA, N.Y. 14120-2421
www.conferladders.com
PRINTED IN USA