Confer Plastics 635-52X Setup guide

CONFER LADDERS ARE DESIGNED FOR EASE OF ASSEMBLY AND ARE CONSTRUCTED
OF MAINTENANCE-FREE, NON-CORROSIVE RESINS AND MATERIALS.
Note: WARRANTY ON PAGE 4. PLEASE SAVE THIS BOOKLET AND YOUR WARRANTY.
• 635-52X Fits Decks 46"-56"
• Easy Assembly
• Adjustable Handrail
Mounting System
Made in U.S.A. by
*Model 635-52X is a
straight up-and-down
ladder and should be
installed 3" to 6" from
the pool wall.
Note: 10 Lbs of
sand required
(See Step 2)
SAND
SAVE THESE INSTRUCTIONS
DEALER/INSTALLER: GIVE TO HOMEOWNER
MODEL 635-52X
ALL PLASTIC INPOOL LADDER
ASSEMBLY AND INSTALLATION MANUAL
Assembly video available online: www.conferplastics.com
WEIGHT LIMIT 250 LBS.

2
Step 1. Step 2.
Step 4.
Step 3. Using a knife care-
fully remove all
four [4] wedges.
Insert tabs on platform
into handrail. Repeat
for 2nd handrail.
Pour 5 lbs
of sand
into each leg.
Fill remainder
with water.
Install threaded cap
over bottom drain hole.
Step 5. Step 6.
Insert wedge into handrail just below the
platfom tab, using rubber mallet tap into
place. repeat to install remaining three [3]
wedges into handrails.
CONFER PLASTICS, INC.
Model #635-52X
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Parts List Tools Needed for Assembly
2 - Handrails * Sand - 10 lbs
1 - Ladder Section * Cordless Drill Motor
1 - Platform * 1/8" Drill Bit
* Phillips Screwdriver
Hardware Pack * Tape Measure
14 - #10 x 1-1/4" Screws * Liquid Soap or Lubricant
1 - Threaded Cap
2 - Mounting Blocks
2 - Adjustable Tubes
If missing parts call - Toll free U.S. - 800-635-3213 or www.conferladders.com
Adjustable
Tubes
Ladder
Handrails
Mounting
Blocks
Platform
Slide the
handrails onto
the legs.
DO NOT
secure with
screws at
this stage.

Used to raise ladder when deck is built higher than
pool. Maximum 2 risers.
Fill with sand and water,
rest ladder on top. Straps included.
3
SKIMS OFF DEBRIS
Cut cleaning time 75% with skimmer extension
that guides debris directly into your skimmer.
Fits most in-ground and above-ground pool
skimmers. Corrosion-resistant plastic Skim-It
installs in seconds without tools.
For winterizing in cold climates remove ladder
from the pool, and drain water from ladder.
ADDITIONAL ACCESSORIES
For #635-52X Ladder
SKIM-IT
EB 100-3" RISER
Step 7. Step 8.
Push the adjustable tubes
up into the handrails.
Coat the adjustable tubes with a little
liquid soap. Slide the mounting block over
the tube and slide all the way down until
resting on the nubs.
Step 9.
Step 10.
Place the ladder into the pool and position mounting
blocks on deck. Slide the adjustable tubes up or down
as needed until mounting blocks are sitting flush on
the deck. Ladder MUST rest on pool bottom. If not,
EB100 riser(s) are required. (See page 3 to order)
Drill four pilot holes (1/8") through holes in
each block into wood surface. Fasten blocks
to deck using the four #10 x 1-1/4" screws per
mounting block. Drill three holes through each
side of each handrail at the pre-marked
locations. Fasten using three #10 x 1-1/4" screws.
Slide down into position
once mounting blocks
have been fastened.
Flush to deck

4
Printed in USA
MADE IN THE USA
CONFER PLASTICS, INC. FIVE YEAR WARRANTY
Confer Plastics, Inc. warrants their swimming pool ladders and steps to be free from
defects in workmanship for five years from date of purchase.
DO NOT RETURN DEFECTIVE PART TO DEALER
E-MAIL CONFER PLASTICS AT: [email protected]
A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,
PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.
INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT: 716-694-3102
OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU
WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND
THE SHIPPING/HANDLING CHARGES.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Confer Plastics, Inc.
97 Witmer Road
North Tonawanda, N.Y. 14120-2421
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX [phone]
www.conferladders.com
SAFETY RULES
* One person on the ladder at a time
* Ladder MUST be installed per manufacturerʼs
instructions
* DANGER: No Jumping or Diving from ladder
* Face ladder when entering and leaving pool
* To prevent entrapment or drowning —
DO NOT swim through, behind or around ladder
*
Ladder to be used as a swimming pool ladder only.
* Weight limit - 250 lbs maximum
*Warning: Exceeding the maximum weight
restriction may cause the ladder to fail.
* Consult your local Building Department before
installation of your pool and equipment.
*DANGER:
Use a cordless drill for assembly
and installation
Never use an electric drill in or around the pool.
3-00-635-X
CP 635-52X 2/17
IMPORTANT
FOR YOUR SAFETY
* Check the contents of the carton with the Parts list
for this ladder.
* If any parts are missing call Toll Free U.S. -
800-635-3213 or visit our web site at
www.conferladders.com
*DO NOT attempt to assemble or install the ladder
if there are ANY shortages of parts or hardware.
* For proper assembly and installation follow all
instructions in the sequence shown.
* Before using the product, after assembly and
installation, go over the instructions and procedures
again to make sure nothing has been overlooked.
* Be sure and safe. The manufacturer IS NOT
responsible for improper assembly, installation
and use.