Confer Plastics CK7100-X User manual

MODEL CK7100-X Conversion Kit (warm gray)
USE CK7100-X CONVERSION KIT TO CONVERT
7100X A-FRAME LADDER TO 6100X INPOOL LADDER
ASSEMBLY, INSTRUCTION AND USE MANUAL
Parts List
2 - Adjustable Tube Handrails (wg)
2 - Mounting Block (wg)
1.
7100X A-Frame Ladder
2. 3.
Swing-up section removed.
To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or
other serious injury or death:
Dealer/Installer: Give manual to homeowner.
Installer: Read "Safe Installation" below and all instructions before beginning. For proper assembly and
installation, instructions must be followed completely.
Homeowner: Read "Safe Use" on back cover before using. Save these instructions.
Installation must comply with local codes and may require permits.
S
Proudly Made in U.S.A. by
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other serious
injury or death:
Check building codes/permitting. Consult your local Building Department before installation of your pool and
equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction and may require
permits (e.g., building, plumbing, electrical, zoning, etc.). Be sure that barriers (fences, gates, etc.) restricting pool
access meet local codes.
Use for intended purpose only
• Use only as conversion kit for ladder.
• When converted, this ladder is designed and manufactured for a specic pool wall height and/or deck of the pool -
check product specication and the height of your pool.
Check that you have all required parts. Check the contents of the carton with the Parts List for this ladder.
All parts and hardware are required. If any parts are missing, DO NOT attempt to assemble or install the ladder.
Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferplastics.com for assistance.
Select an appropriate location - The ladder must be located on a level, solid base and in a location that will be
in full view of competent adult supervision when in use.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the
sequence shown.
• Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during installation.
Cordless drill only - no corded drills near pool. Use a cordless drill for assembly and installation. To reduce the risk of
electrocution, NEVER use a corded drill in or around a pool.
Lift safely. When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to make sure
nothing has been overlooked.
• Make sure that safety labels are installed and legible.
Using a rubber mallet remove
the swing-up portion of ladder
from ladder platform tabs.
5.
Remove the outside ladder
section by tapping on the
underside of platform until
ladder separates.
6.
4.
With a cordless drill, remove
the (2) two screws from the
top of hand rails.
7.
Use only
in pool
section of
ladder with
anti-entrapment
barrier attached.
Slide tube rails
up through
bottom of
platform until seated on tabs.
WARNING! Using
a corded drill near
pool may result in
electrocution.
2 - Adjustable Tubes (wg)
Hardware Pack
14 - #10 x 1-1/4” screw

CP-CK7100-X CON KIT 06/19
12.
Place the ladder in
the desired position
on the deck and
slide the ladder
assembly down until
the bottom tread
meets the pool liner.
Slide the adjust-
able tubes with the
mounting blocks as
needed to position
the ladder correctly
on the deck.
Refer to 7100X
instructions for
adjustment.
Make sure the
bottom tread is
flush with the
pool liner.
Ladder
Assembly.
Slide adjust-
able tubes
to position
against deck.
13.
Using a cordless
drill attach the
mounting blocks
with eight (8)
#10 x 1-1/4”
screws.
Secure the handrail to the tubes using four
(4) #10 x 1-1/4” screws at the
pre-marked locations (two per handrail).
Printed in USA
S
MADE IN THE USA BY:
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX [phone]
www.conferplastics.com
8.
With a cordless drill, re-install
the (2) two hand rail screws.
9.
Slide the mounting block over the
adjustable tube until seated on the tabs.
10.
Slide adjustable tubes into
ladder rails.
11.
Complete
6100X Ladder.
WINTERIZING: Unfasten the ladder from adjustable tubes and remove from the water. Remove
the plugs and lay ladder on its side to drain. It will take several minutes for the water to drain out of the
ladder rails and treads. A small amount of water left in ladder will not cause any damage. Replace the
plugs so they won’t get lost. To reinstall, see Step #12.
Safe Use
To reduce the risk of drowning, entrapment, falls, paralysis, or other serious
injury or death:
Use ladder properly.
• No diving or jumping from ladder - shallow water; risk of paralysis or death.
• FOR ENTRY/EXIT OF POOL, FACE THE LADDER AT ALL TIMES.
• ONE PERSON ON THE LADDER/STAIR AT A TIME.
• To reduce the risk of entrapment or drowning, DO NOT swim through, behind or around ladder.
• Illuminate the ladder when using the pool at night.
Weight limit - 300 lbs maximum. Exceeding maximum weight may cause the ladder to fail.
Secure ladder when not in use.
Watch children at all times when they are in or around water to help prevent drowning.
BE SURE AND SAFE. The manufacturer IS NOT responsible for improper assembly Installation and use.
CONFER PLASTICS INC. FIVE YEAR WARRANTY
Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from defects in workmanship for five years from date of purchase.
DO NOT RETURN DEFECTIVE PART TO DEALER
E-MAIL CONFER PLASTICS AT: [email protected]
A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,
PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.
INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT: 716-694-3102
OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU
WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND
THE SHIPPING/HANDLING CHARGES.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Confer Plastics Inc., 97 Witmer Road, North Tonawanda, N.Y. 14120-2421
WARNING! Using a corded drill near pool
may result in electrocution.
WARNING!
Using a
corded drill
near pool
may result in
electrocution.