Connects2 CAM-MB13 User manual

www.c2vision-eu.com
Image Sensor: 1/3” CMOS
TV Lines: 700
Resolution: 976 x 592
Minimum Illumination: 0.1 Lux (0 Lux when LED’s on)
TV System: NTSC
Infra-red LEDS: Yes (8)
Waterproof Rating: IP68
Viewing Angle: 150 Degrees
Video Output: 1.0V p-p 75ohm
Parking Guidelines: Yes (Removable)
Operating Voltage: 12V DC (Negative Ground)
Operating Temperature: -20 Degrees C to +70 Degrees C
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
High Level Brake Light/Camera
Mercedes Benz Vito 2016 >
PRODUCT FEATURES:
DISCLAIMER:
CAM-MB13

2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Camera with Male 4pin camera connector
• 10m Female 4pin to Male 4pin extension cable
• Female 4pin camera connector to 1x Yellow Female RCA and 1x Female DC
power connector
• 1.5m DC power cable with Male DC connector to bare wires
• Male to Male RCA adapter
• Instructions
INSTALLATION
1. Remove the third brake light from the vehicle and unplug the connection
cable.
2. Connect the CAM-MB13 to the pre-existing connection cable and ret to the
vehicle taking care not to trap any cables.
3. Connect the 4pin of the extension cable to the camera and thread through
the vehicle
4. Connect the other 4pin connector on the extension to the 4pin connector
found on the RCA/DC split wire.
5. Use the DC power cable to plug into the black connector and proceed to
wire the red to a source of 12V and black to a source of ground.
6. Use the Male to Male RCA adpater to plug into the yellow RCA on the
harness, and then plug this into the aftermarket accessory’s video input.
7. Test the camera connection by turning on the ignition. The rear camera feed
should now be visible on screen. Put the vehicle into reverse and the reverse
camera feed will automatically populate on screen.
If camera feed is unresponsive, please uninstall the wiring and reinstall carefully
in accordance with the above steps
8. The camera will be default with parking guidelines. To remove this, simply cut
the green wire found on the camera’s connector.
For further help and support, please contact us directly at
support.connects2.com/tickets/technical
and ll out a support ticket with the full details of your issue.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2