Connects2 CT24JP01 User manual

Dodge
2011-13 DURANGO
Jeep
2011-13 GRAND CHEROKEE
VEHICLE APPLICATI NS
CT24JP01

IS M UNT INSTALLATI N INSTRUCTI NS
1. Attach I O brackets to the rear of the main mounting kit. ( ee Fig B)
2. lide radio into kit from rear & attach to I O mounting brackets using screws supplied
with radio (do not tighten screws at this time).
3. lide radio forward or backward for your desired look and then tighten the mounting
screws. Use I O trim ring when possible.
4. Attach rear support strap to rear of pocket and to rear of radio (optional).
5. Connect all required harnesses into new radio and place assembly back in to sub-dash.
6. Using the factory mounting screws mount the new radio/kit onto sub-dash and put
back the center-dash panel/ radio-trim.
Does not Requires new radio’s metal sleeve (See Fig B)
Trim Ring
(Optional Use)
ITR654
2 3
1. Insert DIN metal-sleeve from your new radio into the radio opening of the
installation kit. ( ee Fig. A)
2. Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
3. lide new radio through DIN metal- leeve until it locks in place.
4. Connect all required harnesses into new radio and place assembly back into sub-dash.
5. Using the factory mounting screws mount the new radio/kit onto sub-dash and put
back the center-dash panel/ radio-trim.
DIN M UNT INSTALLATI N INSTRUCTI NS
Requires new radio’s metal sleeve (See Fig A)
DIN Metal Sleeve
Fig. B
CDK654
ITR654
IMB654R
1. Carefully unclip the entire Radio/Climate Control trim bezel, pull the bezel forward,
then remove trim bezel.
2. Remove the (4) screws securing the radio to the sub-dash.
3. Pull the radio forward, disconnect all attached harnesses and the antenna lead
and remove radio.
DASH DISASSEMBLY INSTRUCTI NS
2011-13 D DGE DURANG /JEEP GRAND CHER KEE
Fig. A
IMB654L