Copernicus Royal RC005 2011 B User manual

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
R
Chart Loop Hook (2)
Rear Frame (1)
Big Book Divider (4)
Metal Shelf (1)
Tub (4)
Bottom Rack (2)
Page Paw (2)
Ultra Safe
Book Ledge (1)
Caster (4)
Front Frame (1)
‘S’ Chart Hook (2) Not Shown
Rear Whiteboard (1)
Royal Reading / Writing Center
Assembly Guide
RC005_2011_B
Check out our other products online at
www.copernicused.com
?This product is meant to be assembled by an adult.
?In its unassembled state, small parts present a hazard.
?To be used under direct supervision of an adult.
WARNING
For assistance, please contact us:
1-800-267-8494
Email [email protected]
Have your packing slip ready for reference
RC005
Please Recycle
Don’t forget to check out our tips for your whiteboard at:
www.copernicused.com

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
Before beginning, you should have:
Hardware
Actual Size
Contents - Box 1
A
2x
B
2x
C
16x
E
12x
F
(Lock Nut)
8x
Additional tools required: Adjustable wrench
In Box 1
Front Frame
1x
Rear Frame
1x
Allen Key
(Not to Scale)
1x
Royal Reading / Writing Center - Parts
D
2x
Contents - Box 2
OR
OR
Metal Shelf
1x
Bottom Rack
2x
Lined Magnetic
Dry Erase Board
(AC455)
1x
Ultra Safe Book
Ledge
1x
Big Book Divider
4x
Bottom
Stretcher
1x
2” Twin Wheel
Locking Caster
4x
Page Paw
2x
Chart Loop
Hooks
2x
‘S’ Chart Hook
2x
Open Tub
4x
Small Tub
8x
Open Tub
1x
Small Tub
2x
Divided Tub
2x
R
PTP1
PTP2
Do not remove
packaging
G
8x
M6 x 50mm Thumb Screws
M6 x 40mm
M6 x 19mm

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
lThis symbol denotes a 2 Person Task. For safety, please ensure that there are two people
working on steps displaying this symbol
lWatch for this symbol throughout the Assembly Instructions. Wherever you see it, pay close
attention. The symbol denotes a step needing extra attention to ensure it is done correctly.
lThe Star symbol highlights an advisory note
Tips for Assembly - Using this Manual
2 Person
Watch for These Helpful Symbols
Before You Begin
As You Assemble the Unit
Layout and identify all of the included parts
l
The hardware has been packed according to size, separate them based on those sizes
l
Read the assembly instructions over once to familiarize yourself with them
l
Please note that in its unassembled state, this product contains parts that can be a hazard
l
to small children; it should be assembled by an adult.
lFollow the steps in sequence
lBefore beginning each step, find the part(s) that you need for that step
lPay attention to the labeling on the parts, they are there to help direct you at certain stages
lThe title of each step states what you will be doing. Review the text and the pictures as you
build the unit.
After Assembly; Before Use
lRemove the plastic film from the Whiteboard before writing on it
lClean the Whiteboard surface well with soapy water and then rinse clean
“The beautiful thing about learning is that no one can take it away from you.” - B. B. King
To validate your warranty submit the ON-LINE form at www.copernicused.com
Validate Your Warranty On-Line
Life
Warranty
Time
Tub Warranty Easel
Life
Time

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
1
Install Board’s Bottom Stretcher
Front Frame x 1Bottom Stretcher x 1
You will need: (Not to Scale)
x 2 x 2
Actual Size: B E
DO NOT TIGHTEN ANY FASTENERS UNLESS INSTRUCTED
BE
EB
!Remove packaging
and slide back into
channel
2
Assembled Front Frame x 1 Rear Frame x 1
You will need: (Not to Scale)
x 2
Actual Size:
D
x 2
E
x 2
A
Fasten Front & Rear Frame Together
!Note placing the unit on its side
will make this assembly easier
D
E
A
D
E
A
Bottom
Channels
should face
each other
!Rotate into
position

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
4
Install Bottom Racks into Frame Channels
Bottom Rack x 2
You will need: (Not to Scale)
x 8
Actual Size: C
2 Person Task
x 8
F (lock nut)
!Install Bottom Racks
before fastening screws
Note: do not over tighten
or Rack will not slide C
F
C
F
3
Install Casters
2” Caster x 4
You will need: (Not to Scale)
Actual Size:
Note: If you cannot push the casters
in by hand, try placing an adjustable
wrench between caster wheels and
then tapping with a rubber mallet
!

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
5
Attach Big Book Dividers to Metal Shelf
Big Book Divider x 4 (Optional)Metal Shelf x 1
You will need: (Not to Scale)
x 8 x 8
Actual Size: C E
NOTE:
Dividers provided are
optional.
You may prefer to lay your
books flat for storage, rather
then standing.
If you choose to lay books
down flat, you do not have to
install the Big Book Dividers
To leave your shelf open,
skip this Step.
The Big Book
x 8
G
!C
E
G
x 8
x 8
x 8
6
Install Book Shelf into
Assembled Frame
At this point, your Shelf may or
may not have Dividers installed
on it, as per the decision made
in the last Step.
Tighten
Thumbscrews (2)
at top of unit
Note: Place Metal
Shelf on unit through
back of Frame

RC005 Assembly Instructions - Version B - Released 21 October 2011 - Copernicus Educational Products Inc.
7
Install Book Ledge
There are four (4) positions on the front and
five (5) on the back of the unit for your
convenience. Choose the one that works
best for your classroom.
1) Insert one hook into the appropriate hole on
one side of the Whiteboard Frame
2) Pull out opposite hook & snap into place
Note: The spring tension is designed to
discourage children from unhooking the
Book Ledge
Book Ledge x 1
You will need: (Not to Scale)
Actual Size:
8
Attach ‘S’ Chart Hooks & Chart Loop Hooks
‘S’ Chart Hooks x 2 Chart Loop Hooks x 2
You will need: (Not to Scale)
Actual Size:
Snap
Tip: place empty hardware bags over
the frame to prevent scratching.
Lined Magnetic Dry Erase Board x 1