Courtyard Creations TGS37SC User manual

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
STOP DON’T RETURN TO STORE!
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside facing
upwards. Insert the legs (#2) into the plastic
holders attached on the underside of the table top
(#1) rim. Fasten them together by using screws
(#4). See Figure 1.
PAGE 1 OF 2
FIGURE 1
TGS37SC
1
2
3
4 4
1
4
1 5
6
7
8 1
8
8
8
TGS37SC-CS05-1
TGS37SC-CS04-1
62TGS37SCY101
17C17A0403001Y4 17KAA0201----Y4
18000337002
17FA05040301-Y4
17C01A0706002Y4
BOLT M6*16
WASHER d6.5*D13*1.0
BOLT CAP M6
HEX.KEY WRENCH 6MM
PARTS LIST
PART
NO. MATERIAL CODE Q’TYPART PART NO. MATERIAL CODE Q’TYPART
TABLE TOP
LEG
CENTER
CONNECTOR WITH RING
SCREW ST4.2*12
You will need the following tools:
- Phillips Screwdriver (Not Included)
- Hex. Key Wrench (See Part #8) 2
2
2
2
1
4
Attention:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
COURTYARD CREATIONS INC.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
!
!
!
!
!
!
!
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is completely
assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and
fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote following FQC NO. when contacting service center.

PAGE 2 OF 2
Step 2:
Fasten the center connector with ring (#3) to the
middle of the legs (#2) by using bolts (#5) and
washers (#6). Make sure that all of the bolts have
been tightened completely and cover them with
bolt caps (#7). See Figure 2.
Step 3:
Turn the table to its upright position. See Figure 3.
FIGURE 3
FIGURE 2
2
2
2
2
3
55
6
6
77
Note:
To use an umbrella with this table, remove the
plastic center plug and put the umbrella pole
through the table top and center connector ring.
Cleaning and Maintenance
•Wash frame parts with mild soap and water, rinse thoroughly, and dry completely. Do not use bleach,
acid , or other solvents on the frame parts.
•Wash glass with mild soap and water, rinse thoroughly, and dry completely.
•Inspect and tighten all bolts and fasteners on a regular basis to ensure the proper performance and
safety of your table.
• When moving the table, remove the umbrella and lift. Do not drag this table.
• We recommend the use of furniture covers when not in use.
• In order to prolong the life and beauty of your table, we recommend that it be stored in a dry and
protected area during off season periods.
• Tempered glass has been used for increased strength and safety of your table. However, during windy
conditions the umbrella should be lowered and/or removed.
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
Missing A Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
For further assistance,
please visit us at
[email protected]
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL PARTS, MAKING SURE THAT YOU
HAVE ALL OF THEPARTSLISTED.
IF YOU DO NOTLOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCEANY DIFFICULTY DURING ASSEMBLYOR IF ANY
PARTS ARE MISSING OR DAMAGED,CALL THE HELP LINE AT
1-877-539-7436 BEFORERETURNING THIS ITEM TO THE STORE.
PROVIDE THEFOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS
LIST.
MOST PROBLEMS CAN BERESOLVED WITHOUT RETURNING THIS
PRODUCT TO THERETAILER.
STOP DON’T RETURN TO STORE!
Warranty
•This product is covered by Courtyard Creations Inc. One–year limited warranty.
•Proof of purchase (dated register receipt) is required for warranty claims.
•It remains the customer’s responsibility for freight and packing charges to and from over service center.