Crestron HRI-150 Dimensional drawing

DO GUIDE
DO Check the Box
QTY PRODUCT PART NUM.
2Batteries, AAA Alkaline, x2 2041725
1Keycaps, 100 4521158
Items for HRI-100 Only
1Cover, Button, Removable, 2-Button 4520730
1 Cover, Button, Removable, No Button 4520731
Items for HRI-150 Only
1Cover, Button, Removable, 6-Button 4520696
1Cover, Button, Removable, 4-Button 4520697
1Cover, Button, Removable, 2-Button 4520761
1 Cover, Button, Removable, No Button 4520695
2. Remove the buttons as desired.
HRI-100/HRI-150
Handheld Remote, 34/50 Button
DO Change the Buttons and the Cover
The HRI-100 and HRI-150 ship with all of the buttons installed (four on the HRI-100 and eight on
the HRI-150). Both remotes can be used with none of the buttons installed or two of the buttons
installed. The HRI-150 can also be used with four or six buttons installed. Both remotes ship
with alternate button covers.
To change the buttons and the cover, use the following procedure:
1. Gently separate the button cover from the remote.
Separate the button cover here.

DO GUIDE DOC. 7790B (2043957) 05.16
Specications subject to change without notice.
3. Gently snap the appropriate new button cover into place. DO Acquire the Remote
Before an HRI-100 or HRI-150 can be used with a Crestron®control system, it must rst be
acquired by an inNET EX®Wireless Gateway or a control system with a built-in inNET EX
gateway (all sold separately).
1. Press the ACQUIRE button on the gateway to enter Acquire mode.
2. On the HRI-100 or HRI-150, press the Backlight button four times, holding it down
on the fourth press (press, press, press, press+hold). After a few seconds, the backlight
ashes, indicating the remote is now in Acquire mode. The remote is automatically
acquired by the gateway within two minutes. When the remote has joined the network, the
backlight turns on for ve seconds.
3. When the process is complete, press the ACQUIRE button on the gateway to exit Acquire
mode.
DO Learn More
Visit the website for additional information and the latest rmware updates.
To learn more about this product, use a QR reader application on your
mobile device to scan the QR images.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specications for CE marking. Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a limited non-exclusive, non-transferable Software Development Tools
License Agreement. Crestron product operating system software is licensed to Crestron dealers, CSPs, and end-users under a separate End-User License Agreement. Both of these Agreements
can be found on the Crestron website at www.crestron.com/legal/software_license_agreement.
The specic patents that cover Crestron products are listed at http://www.crestron.com/legal/patents. The product warranty can be found at www.crestron.com/warranty.
Certain Crestron products contain open source software. For specic information, please visit www.crestron.com/opensource.
Crestron, the Crestron logo, inNET EX, and the inNET EX logo are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. Other
trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any
proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2016 Crestron Electronics, Inc.
HRI -10 0
HRI -15 0